Electronics Forum | Wed Jun 19 11:34:37 EDT 2013 | chifutbol
"The disk of B drive has not been formatted as a PCB Data disk." This is the error I'm getting when trying to install lines on a new installation of the Gemline PCB Editor. I have tried using a new floppy, formatted in both opal and topaz machines,
Electronics Forum | Wed Dec 09 15:50:09 EST 2009 | propox
Hi We have several Philips Topaz machines and old PPS, where can I find new GemLine-PPS v8.0 software, I have freeware cad2cad but it is simple. Any help please
Electronics Forum | Mon Jun 30 00:50:57 EDT 2008 | benefon
Hi There are many ways of doing this but I usually transpose the coordinates to the lower right hand corner of the sub-panel that is situated at the lower right hand corner, because the reference point of the machine is the right hand side locate pi
Electronics Forum | Wed Dec 09 18:37:05 EST 2009 | smt_guy
do you plan on purchasing the software?
Electronics Forum | Mon Sep 13 07:14:34 EDT 2010 | mun4o
Hi all, we have two smd line, with 2 topaz X each.Software for optimizing is PPS v.8.0.The problem is that when PPS optimazing the programme, IC, diodes and other polarity components are with wrong orientation.But, I see the orientation onli when str
Electronics Forum | Sun Jun 29 11:46:26 EDT 2008 | johnnie52
I'm new at this and any help will be appreciated. I received cad data from a customer and need to get it loaded into a Topaz system. The data is for a single board but the production board is panelized and has edge rails. This means that the actual
Electronics Forum | Fri Sep 19 12:18:57 EDT 2008 | mikesewell
Assembleon/Philips has their own offline programming software (PPS Gemline) to take you from CAD (they should have a gerber utility) to machine program. A lower cost aproach is something like GC-Preview with the "Plus" option to extract centroids, t
Electronics Forum | Fri Sep 19 16:54:29 EDT 2008 | snsmt
Assembleon/Philips has their own offline > programming software (PPS Gemline) to take you > from CAD (they should have a gerber utility) to > machine program. A lower cost aproach is > something like GC-Preview with the "Plus" option > to extra
Electronics Forum | Thu Jun 18 08:28:23 EDT 2015 | grimus
They change software and moved to different one. The only thing You can do I think is contact with Assembleon (previously Philips) with request to re-create license code or buy new software. Unfortunatelly if you are changing hardware (PC) than it mi
Electronics Forum | Tue Sep 14 00:35:47 EDT 2010 | sachu_70
The PPS helps to prepare a program off-line without affecting on-line production. However, there are certain efforts that we must consider, such as identifying the part orientation on feeder vis-a-vis its placement orienation on PCB, and confirming s
