Electronics Forum | Mon Feb 06 09:24:15 EST 2006 | cyber_wolf
I take it you are talking about the older style IP feeders. If so, here is what you need to do..... Get yourself some mineral spirits,a tub you can submerse the parts in, and a couple nice paint brushes. 1.Dismantle the feeder and wash all of the
Electronics Forum | Sun Feb 05 13:41:47 EST 2006 | bvdb
We recently purchased an old Fuji IP-I placement machine and have been testing 8x4 feeders for 0805 parts, etc. I have opened some of the non-working feeders to replace broken pieces and have noticed that some of the feeders are completely clean ins
Electronics Forum | Mon Aug 17 15:19:16 EDT 2020 | jmelson
I have a (new to me) Quad QSA-30A that I just got about a week ago. At first, I could get it to go ready most of the time, now it will never go ready. I have traced the ready button into the DPRAM board and the logic is OK all the way into one of t
Electronics Forum | Fri Feb 07 20:38:16 EST 2020 | orbitcoms
I am running a Sasmsung CP40-LV machine (which itself works fine). However, the thing holding up production is that I am often experiencing tape cover not being pulled back by the feeders. What part of the feeder is most likely to cause this? I have
Electronics Forum | Sun Feb 09 18:20:24 EST 2020 | richardcargill
Does this only happen with certain feeders or certain components? We have a few regularly used components that experience the same problem ( Philips SMT machinery ) where the cover tape is just too sticky. Experience taught us which components will c
Electronics Forum | Wed Mar 20 12:59:10 EDT 2013 | kmots15
We had this issue with a few parts on our universal 8mm feeders. The set up was correct all mechanisms were working, even tried a new feeder. The spring in between the take up wheel and pick point just wasnt cutting it since the adheasion was too m
Electronics Forum | Wed May 03 13:27:32 EDT 2023 | dilogic
Genesis should work with pneumatic feeders, but not if Lightning heads are used. It's basically 24V transformer and some wires and fuses - you can do this "upgrade" by yourself, actually. Regarding cal. kit - it's the same as for GSM's but, again, no
Electronics Forum | Mon Oct 09 14:09:06 EDT 2017 | ilavu
Make sure that you have some feature on the part to get orientation check. We tried long time ago and it did work on GSM with 4 spindle. For us, setup the vision system was the challenge for correct rotation using vib feeder.
Electronics Forum | Sat Feb 03 10:51:47 EST 2007 | Sami
Hello to all. I have faced with a strange problem with Universal machine GSM Genesis, After an 8 hours of production without a Stop then, the M/C starts displaying components non aailable for many feeders in the same feeder bank! eventhough the feede
Electronics Forum | Fri May 04 08:53:48 EDT 2007 | davem
I have been working with the UIC GSM platform for 6 years now in an EMS environment. Operating, programming, configuration, and line installation. I do not work for Universal or represent them in any way. UIC is a 1st rate company with excellent and
