Electronics Forum | Mon May 18 17:59:06 EDT 1998 | Richard Jackson
I've tried every thing I can think of. Do you have any Ideas? What I have is micro balls on the gold fingers of panelize boards. These balls only appear on the gold finger. Or at least I can only find them on the gold fingers. What I have tried so
Electronics Forum | Thu Oct 28 18:14:51 EDT 1999 | John Thorup
Try looking for paste contamination somewhere. Dirty stencil, printer table or fixtures. Placement table/fixtures. Reflow belt/conveyer. Reuseable finger covers, if used. Try covering the fingers with Kapton tape during different stages of the proc
Electronics Forum | Fri Oct 05 18:59:53 EDT 2001 | Dan Steffler
I have had an issue where solder has contaminated gold plated pads (fingers) where it is not acceptable. The pads must remain perfectly coplaniar for a LCD zebra strip to lay accross them. Does anyone know of a way to remove the marriage level of s
Electronics Forum | Tue Jun 28 18:20:49 EDT 2005 | russ
Matt, have you run a profile on this board? Just because it's .062" doesn't mean that any old .062" profile will work. We have .062" thick boards that almost nil for copper and other are utilizing 2 oz. layers internally. They require quite diffe
Electronics Forum | Sun Jan 23 03:23:09 EST 2000 | Rob Steltman
Hi We use a U-channel piece of high temperature silicon which is just pushed over the gold tabs before the soldering process. The silicon can be used over and over again. The advantages are that there is no mask on the board during the SMT process a
Electronics Forum | Tue Jul 01 17:38:24 EDT 2003 | jartman
I've faced this several times in the past, and the only real solution is to wirebond before SMT assembly. Everything leaves a residue, and trying to clean a residue off later is basically hopeless. This may require some trickery in your SMT process
Electronics Forum | Wed Jan 14 06:42:38 EST 2004 | tommy
We see spattered(spitting of flux or solder to nearby area) solder/flux on gold fingers.We view the gold fingers area under 30x before reflow and it is cleaned but after reflow we see flux droplets or solder on gold fingers. We tried to changed a new
Electronics Forum | Wed Jan 14 08:28:46 EST 2004 | davef
Search the fine SMTnet Archives for background on solder on gold fingers. As we recall: * Paste selection * Proper reflow recipe tuning ... are important.
Electronics Forum | Tue Sep 05 03:09:57 EDT 2000 | Gyver
Hi Dave, Thanks for your great help! Well, gold fingers are always on any kind of cards, right? Or you were confused by my poor English...sorry!:-( Now we are going to implement some kind of method to prevent the gold fingers from being contaminated
Electronics Forum | Mon May 18 21:29:38 EDT 1998 | D.Lange
| I've tried every thing I can think of. Do you have any | Ideas? | What I have is micro balls on the gold fingers of | panelize boards. These balls only appear on the gold | finger. Or at least I can only find them on the gold | fingers. | What I