Electronics Forum | Wed Jun 17 10:02:38 EDT 2015 | rgduval
Having some issues with our GSM picking parts that are delivered by the PTF off center; and wondering if there's a relatively painless way to calibrate where the head goes to pick the part on the belt. Near as I can see, the PTF is picking the parts
Electronics Forum | Fri Sep 23 09:53:33 EDT 2005 | PWH
Thanks all for the opinions. Our shuttle/GSM1/PTF install was done by an ex-UIC engineer. Have never utilized shuttle so appreciate the advice on pros and cons of it all. We have 1.0 mil on PTF side and 4.0 on shuttle side. C4 head on both sides
Electronics Forum | Wed Dec 21 08:30:13 EST 2005 | jax
"aj" you should find your way to a training class. The measurement is from the zero point of the tray feeder( almost always the feeder slot pin giude that the center guide of the tray holder hits...located in the machine ). It is not the same as nest
Electronics Forum | Fri Nov 09 14:30:17 EST 2001 | vickt
FYI...Universal has software that "senses" if parts are present in the PTF trays or not. With some upgraded s/w your dumping would be over
Electronics Forum | Thu May 19 08:56:38 EDT 2005 | marcelll
On the GSM, the board width is usualy 18" maximun. But there's a lot of possibility depending if you have a PTF or where's yours changers and the block #
Electronics Forum | Wed Nov 13 16:27:40 EST 2019 | ilavu
Tom, Did you put the machine in debug mode? Do you use RAMTF or PTF? Based on your problem, check PilZ box.
Electronics Forum | Fri Aug 21 11:13:42 EDT 2009 | voytek
Hi, I am looking for Stationary Matrix Tray Feeder P/N 44976203. Thank you,
Electronics Forum | Thu Sep 22 18:15:51 EDT 2005 | PWH
Does anyone have experience using a shuttle on a GSM platform? I'm just wondering how well it works and how reliable and trouble free the component picks are. I am looking to run a low volume line with a printer/oven and a GSM1 platform with a PTF
Electronics Forum | Wed Jun 17 14:34:22 EDT 2015 | rgduval
Thanks for the shot at it :) So, I discovered the "feeder teach" feature that UIC has in the software. It's fantastic...except it doesn't give the option to have the PTF deliver a part to the belt. That was mildly disappointing. In the help files
Electronics Forum | Fri Sep 23 23:21:53 EDT 2005 | Mats
Please explain Your line configuration needs or the volume by: components/panel/day/operators(people)/investments/yield/customer requirements/Your own req./etc. that You need. In Your initial thread You said that You had a low volyme production and
