Used SMT Equipment | In-Circuit Testers
Tektronix RSA3408A Trigger, Capture, Analyze WLAN, Radar, 3G, or other Time-Varying RF Signals High-resolution spectrogram reveals transient signal behavior that translates to rapid problem solving. Here, 500 kHz sidebands are revealed as part
Used SMT Equipment | In-Circuit Testers
Agilent N9020A Standards evolve, product cycles get shorter, and each project demands tradeoffs and decisions about specs and capabilities, about throughput and yield. A highly flexible signal analyzer helps you make solid choices and keep things
Electronics Forum | Wed Dec 29 18:01:13 EST 1999 | JAX
What's happenin Larry, I am not sure if bump proccess E is available on this particuliar software rev. but I have forgotten?????? It shouldn't matter; bump proccess A will work fine. The only things you have to do is make sure the pick up point
Electronics Forum | Thu Feb 02 13:22:58 EST 2017 | jluiscp10
Hi. We Recently adquired a used machine universal GSM2, (product tree #46368504 L524), we need the operation, programming, platform operation, PTF basic machine operation manuals. Could you help me with this? Thanks
Electronics Forum | Tue May 01 20:18:37 EDT 2001 | jwdyer
I have a PTF that is blowing the MMIT card on the PTF. Anyone have any ideas why? It's OK until the PTF begins the zero process. Thanks, Dyer
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Wed Jun 17 10:02:38 EDT 2015 | rgduval
Having some issues with our GSM picking parts that are delivered by the PTF off center; and wondering if there's a relatively painless way to calibrate where the head goes to pick the part on the belt. Near as I can see, the PTF is picking the parts
Electronics Forum | Fri Sep 23 09:53:33 EDT 2005 | PWH
Thanks all for the opinions. Our shuttle/GSM1/PTF install was done by an ex-UIC engineer. Have never utilized shuttle so appreciate the advice on pros and cons of it all. We have 1.0 mil on PTF side and 4.0 on shuttle side. C4 head on both sides
Electronics Forum | Fri Nov 09 14:30:17 EST 2001 | vickt
FYI...Universal has software that "senses" if parts are present in the PTF trays or not. With some upgraded s/w your dumping would be over
Electronics Forum | Thu May 19 08:56:38 EDT 2005 | marcelll
On the GSM, the board width is usualy 18" maximun. But there's a lot of possibility depending if you have a PTF or where's yours changers and the block #