Electronics Forum | Fri Sep 22 00:57:44 EDT 2023 | hazira1991
The actual root cause not yet define. But i do check all that you stated all good setting parameter. 1 week before run the problematic batch, i had run another batch which all the BGA were good no solder short. Just recently i run another batch 21 pc
Electronics Forum | Sat Apr 16 13:43:53 EDT 2005 | KEN
What about electo migration? I had (what apears to be) the exact same problem you describe. X-ray and ICT fails to detect micro shorts. However, in our test, the bench functional test would show a current overload. In some cases the electro migrti
Electronics Forum | Sat Sep 25 07:07:02 EDT 1999 | Brian
| I need a memory jog. What is the term for the growth of conductive contamination after a board is in storage or field? | There are several different mechanisms which can cause this. In reality, ionic contamination is the root cause for many of the
Electronics Forum | Tue Sep 01 19:31:36 EDT 1998 | Kallol Chakraborty
| We are experiencing shorting on a BGA. The part has a 1mm pitch with a 196 I/O count. The problem seems to pop up without warning & disappear in the same manner. | Our pad design is .020" diameter pads with .025" solder resist diameter. The ce
Electronics Forum | Mon Aug 07 04:05:43 EDT 2023 | suradi
May I share regarding this issue. Initially, please define the root cause clearly, is it from materials or process. Refer to the picture, if the short location is not randomly meaning there is the process issue. It could be stencil design or paste pr
Electronics Forum | Fri Jun 23 14:10:01 EDT 2000 | Chrys Shea
Sounds like the mask to me. Had a similar situation a couple years ago. The mask wasn't fully cured, so it absorbed water that the preheaters couldn't dry out. When it outgassed at the wave, it caused a lot of micro turbulence that broke the surfa
Electronics Forum | Wed Sep 02 08:44:50 EDT 1998 | Kelly Morris
| Hi, | We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent it.
Electronics Forum | Sun Dec 09 22:54:20 EST 2001 | dburr
It sound you have already discovered to root cause, flux entrapment in the via holes. Short of changing the desing, here are sone suggestions. The main thing is you have to dry out the via holes of the wet flux. Some things to try are: slow down t
Electronics Forum | Wed Nov 11 10:08:38 EST 1998 | Magnus
| | Hi, | | We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent
Electronics Forum | Fri Mar 26 03:25:02 EDT 2010 | grahamcooper22
HI, regarding the baking....why are you doing it every 72 hours ? How many times has each device been baked ? If you are worried about moisture in the devices the best policy is to store them correctly in dry packs or dry cabinets or bake them once j
