Electronics Forum | Tue Aug 23 22:50:09 EDT 2005 | adeline_ko
My process guy told me that. Due to black spot issue, brd with BGA must use electrolytic finishing. And when we had this finishing with plug via, the blister issue pop out. My supplier claim that this is due to the plug via. Which I don't know how
Electronics Forum | Fri Jul 09 16:32:35 EDT 1999 | John
Thanks everyone. I appreciate the help. John | Q #1) Is it more reliable to have the mask tent over the vias or risk getting vias half filled with solder? These are vias with an .020" hole and .040" or .050" pad. | | Q #2) When speaking of annular
Electronics Forum | Fri Oct 03 05:59:20 EDT 2014 | cmchoue
Does anyone well know in "via hole design in ground pad" I have few question that i want to know the answer,thanks. 1.Thermal performance compare about a.Via Full Stuff (top/bottom:solder mask and inside is air) b.Via Half Stuff (bottom:solder mask
Electronics Forum | Wed Feb 07 13:43:33 EST 2007 | realchunks
Board vendors are always right. Unless you build yourself in their facility, at their price. Ways around this are half etch your stencil over the vias, open the resist (mask) on the vias, or use your own product (Sipad). The resist (mask) does app
Electronics Forum | Tue Dec 19 21:23:39 EST 2006 | davef
We'd suggest using your connector supplier recommendations. Some use: * Pad Plating: 20-30 uin Au over 50 uin Ni (You might get away with less gold) * In-Pad Vias: less than half the diameter of the button (for contact-only configurations) * PCB/C
Electronics Forum | Mon Jan 31 08:30:41 EST 2005 | davef
Yes, probing via is perfectly acceptable. Via: * Pad diameter is 0.028 inch * Via pitch minimum is 0.50 inch ... all of which is fairly common, even when probing test pads. [Your English is fine, at least as good a half the English speakers here.]
Electronics Forum | Tue Jul 15 16:12:23 EDT 2008 | boardhouse
Hi Armynski, I sell for an offshore board house, yes, it is common for offshore board shops to fill vias. The bubble is caused by air entrampment within the hole it self, when heat is applied during Hot air and the via is covered on both sides the e
Electronics Forum | Tue Sep 26 20:50:06 EDT 2000 | Dave F
Right!!!! We have built product with via holes only 0.010" off the edge of the routed edge or even routed them in half, which usually adds cost and shorts to the chassis. Most high speed routing has a tolerance of +- 0.005". It's common for UL fi
Electronics Forum | Fri Jun 04 11:31:27 EDT 1999 | Tony
| I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole." The
Electronics Forum | Fri Jun 04 03:03:52 EDT 1999 | Scott B
| I'm encountering a new problem at my new company that I haven't encountered before in my past life - and that's Wave Soldering VIA holes. | | We've been getting a rash of defects that we call in this company, "insufficient solder in VIA hole." The
.png)