Industry News | 2011-07-13 18:24:32.0
The premier model in Manncorp’s line of surface mount rework systems, the BR810 is designed for safe removal, precise placement, and reliable soldering of the most delicate and sensitive SMD packages found in the industry’s most challenging board repair applications.
Industry News | 2012-04-10 14:47:49.0
The Balver Zinn/Cobar Group announces that its SN100C Wire Solder and Cobrush flux applicator were demonstrated at the first Hand Solder Competition at the recently held IPC APEX EXPO in San Diego.
Industry News | 2011-02-21 18:54:18.0
JTAG Technologies has once again boosted the performance of its industry-leading ProVision suite of boundary-scan development tools with the addition of 11 enhancements and will present this amongst other new products at Apex 2011, booth 1638.
Industry News | 2016-05-13 11:56:03.0
The process of manufacturing and qualifying IC's consists of many steps while Temperature forcing systems play a crucial role in the final testing process. These environmental tests assure quality and reliability by stressing the device on one hand as well as helping to characterize and validate it on the other hand (making sure manufacturing outcome meets the design requirements). At later stages the temperature testing can support failure analysis effort and root cause analysis. AS common practice we are dealing with few different kinds of temperature forcing systems: Chambers, Thermal Stream systems and Direct Thermal Head systems. In this article I would like to focus on the practical aspects of utilizing Thermal Stream systems and Direct Thermal Head systems.
Industry News | 2016-05-13 12:00:12.0
The process of manufacturing and qualifying IC's consists of many steps while Temperature forcing systems play a crucial role in the final testing process. These environmental tests assure quality and reliability by stressing the device on one hand as well as helping to characterize and validate it on the other hand (making sure manufacturing outcome meets the design requirements). At later stages the temperature testing can support failure analysis effort and root cause analysis. AS common practice we are dealing with few different kinds of temperature forcing systems: Chambers, Thermal Stream systems and Direct Thermal Head systems. In this article I would like to focus on the practical aspects of utilizing Thermal Stream systems and Direct Thermal Head systems.
Industry News | 2021-05-31 21:38:35.0
It goes without saying that correct dimensional measurement is a key factor in manufacturing. Performing measurements with the same reference throughout all processes from material reception to processing, assembly, inspection, and shipping make it possible to create products that match the design exactly and to guarantee product quality. Thus, it is essential to perform correct measurements throughout every step of the manufacturing process. Correct measurements can be done by making sure that all those involved in manufacturing are skilled in measuring, and that the measuring instruments are correctly managed and used.
In the world of makers, people enjoy the fun of designing and developing hardware/ software, even final electronic products. They will not concentrate a lot on the cost and manufacturability. But it is quite different from lab to factory, when it com
Industry News | 2021-09-14 02:08:49.0
In this article, I will talk about Top 10 Common Mistakes in PCB and PCBA Developing when makers/ startups/ engineers design a new electronics hardware products.
Electronics Forum | Fri Oct 03 05:55:14 EDT 2003 | kanwal324
Can paste height be measured by IR rays instead of Laser rays. Any tool available.
Electronics Forum | Mon Oct 24 09:07:58 EDT 2016 | robl
Could you make up your own adaptor cable to connect to your programmer, then fit a small form connector like a Firewire on the edge of the PCB? It should only take up about 7x7mm of real estate as opposed to a 2.54mm 5x2 pin header 12.7 x 5.08, or a