Electronics Forum | Thu Dec 16 20:41:56 EST 1999 | TNT
Hey C.K, If you are looking for inspection of the solder paste before reflow, there are many types of inspection: 1.Paste height measurements at random positions 2.3D inspection with shadow contrast capabilities based on an autocad format 3.3D inspec
Electronics Forum | Mon Mar 30 15:16:32 EDT 2009 | Peter
Hi Tom, You're right. I do find the second locating pin hardware. Now I got them both up/down when F3 is pressed. Thanks. I don't see any pin on the hardware and no edge clamp hardware either :-( , do you know any way that I can bypass these hardware
Electronics Forum | Mon Jul 10 09:32:35 EDT 2017 | georgetruitt
You need to find a machine that has a camera with adjustable focal height. Fixed cameras can inspect most smt components but soon reach their limits when it comes to inspecting taller components like thru hole. Yes, there are many AOI machines out
Electronics Forum | Fri Mar 06 19:32:09 EST 2020 | SMTA-Alex
The fact, that your Hydra head goes up and then starts moving slowly, means that it didn't find the limit. Since there are no mechanical obstructions and you swapped all the boards, the things to look at are cabling. Double check the ribbon cables fo
Electronics Forum | Mon Oct 05 17:07:31 EDT 2020 | dekhead
Older machine models (Horizon / Infinity) allowed you to offset the board stop (thru crative programming) to run the larger board with parameters for the smaller board. That feature is eliminated with the Micron series. However, if you can get remote
Electronics Forum | Tue Nov 01 09:36:41 EDT 2011 | emeto
THe question is - does that happen on all of your programs or just in one program? If it is just this particular board, it might be some softwaRE limit issue. If it happens on more programs it is a hardware issue and it could be one of the following:
Electronics Forum | Fri Oct 02 13:55:58 EDT 2020 | lesfarnacer
hi , need help please with my DEK Horizon 03i , we trying to programme a longboard 600mm on the printer and board lengh on our printer is limited to 510mm . I checked on the hardware eve thing is ok but in the software we don't have the longboard op
Electronics Forum | Sat Mar 10 08:05:09 EST 2007 | davef
Here's your test definitions [clipped from the dictionary in the fine SMTnet Library]: * Test, Automated. Computer controlled electrical testing of parts, assemblies, or finished products. * Test, Built-In (BIT). An electrical testing technique whi
Electronics Forum | Tue Jan 10 16:01:20 EST 2017 | davef
A review document for J-STD-001F with Amendment 1 had the following wording, but you should check the actual document to be sure of correctness 4.2 Facilities Cleanliness and ambient environments in all work areas shall [D1D2D3] be maintained at le
Electronics Forum | Fri Oct 26 11:29:41 EDT 2001 | kaopsahl
I have two DEK 288s set up in our shop, we used to use a Fuji GSP_III. I could not possibly say enough good things about the DEKs - they are incredible. The only real complaint I have with them is that if an error pops up that locks up the software -