Electronics Forum | Thu Jul 23 06:15:33 EDT 2020 | bukas
There is a oven setup wizard on my 1809. your oven probably has one too. there you should be able to adjust blower speed for each zone.
Electronics Forum | Thu Jul 23 10:12:27 EDT 2020 | cyber_wolf
Blower speed control is an option. If you have it, there will be an icon on the toolbar. Hover the mouse over the buttons for description.
Electronics Forum | Thu Jul 23 13:44:50 EDT 2020 | dwl
I used to have the same issue with reed switches on one product we ran. Same oven too. We ended up rigging up an "umbrella" with two titanium stiffeners and bare PCB as the roof. It was hokey but it worked.
Electronics Forum | Mon Jul 27 20:26:44 EDT 2020 | kghadiya
Good idea DWL, "Umbrella" thing works to solve this problem temporarily. But do you think it will cause any damage to hitter or heat zone?
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Tue Sep 15 21:05:37 EDT 2020 | bmalhi
Please try to run wakeup recipe and heat up one zone at a time to see if its related to any zone or load on the facility side. Please contact Heller ServiceNJ@hellerindustries.com to get help with the issue.
Electronics Forum | Tue Sep 15 14:42:20 EDT 2020 | kumarb
Some threads that may help: https://electronics.stackexchange.com/questions/398199/filter-harmonics-in-ac-power-line still recommend that you contact Heller for advice. Consider to insert a UPS system between your hydro and one of the LED light fi
Electronics Forum | Mon Sep 14 20:19:33 EDT 2020 | kumarb
Hi. 1) recommend to phone up Heller for assistance on this case 2) using the wakeup profile, can you confirm if the problem remains or not when you skip the warm up of zone # 2? 3) each zone is based on 2 heaters (this is what we have on our 1809e
Electronics Forum | Thu Sep 17 13:26:45 EDT 2020 | emeto
New factory - old oven. Something is different in power in the new place. Compare with old place and fix.
Electronics Forum | Sat Sep 12 04:19:28 EDT 2020 | SMTA-64387098
I have just built a new factory and installed the old Heller 1707 XL oven. When I run the oven the LED panel lights and downlights in the entire building begin to shimmer after 2nd zone is switched on. It does not get worse when the whole 7 zones are
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
