Electronics Forum | Thu Jul 17 08:28:20 EDT 2008 | jdumont
With our last two ovens (Heller and now BTU) spanning the past 7 or 8 years I did it once a month and have never seen any issues. Reflow ovens these days with PID controllers know exactly what they are doing inside well before you run a profiler thro
Electronics Forum | Wed Aug 13 09:54:41 EDT 2008 | slthomas
+1 on what robgd3 said. It's basically the same process. The bummer is that you only have three thermocouples to give you the information you need, so placement (and attachment) is more critical. You also don't have the predictative capability of
Electronics Forum | Tue Feb 19 10:50:13 EST 2019 | rgduval
Call Heller directly, and give them the oven, and relative thermal density of the board, as well as the solder paste that you're using. They'll be able to give you a baseline profile to start from (both RTS and RSS). Otherwise, use a thermocouple p
Electronics Forum | Tue Feb 19 12:28:26 EST 2019 | slthomas
Presumably you're talking about lead free, but you don't say. Heller can probably provide you with a starting point, as rob has already pointed out, but you do need to develop the capability to perform profiling yourself. That oven should have ECD
Electronics Forum | Tue Aug 27 16:39:39 EDT 2019 | spoiltforchoice
There is no formula out there that chooses a model for low volume high mix. Every oven can manage the throughput, which leaves us with cost, servicing, flexibility and reliability. Ersa Pros: Longer heated length than the ovens I am comparing it t
Electronics Forum | Thu May 18 08:31:28 EDT 2006 | marc
Hi James Short answer... yes... long answer...impingement velocity is excellent for heat transfer but it also is a higher risk of moving components. Variable speed blowers allow you to reduce the speed / impingment and more than likly your compone
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Thu Sep 16 12:06:29 EDT 1999 | Scott S. Snider
| | | Hi, | | | | | | Can someone pls suggest to me the best reflow temperature setting | | | for a force air convection oven. The details is as follow. | | | 1) Heller 1700s | | | 2) 12 zone---6 top and 6 bot | | | 3) Solder paste --- Qualitek 691
Electronics Forum | Tue Nov 13 00:05:11 EST 2012 | eadthem
Typical problems with our heller 1707 EXL would be blower issues. We have almost replaced every blower on the top sense purchase. Fortunately Heller is very good about honoring there warranty on the blowers which is quite long, Might be lifetime not
Electronics Forum | Thu Jul 15 10:33:59 EDT 1999 | Michael Zadrejko
| | I am trying to solder a 388 ball BGA to an Andon Electronics Corp. BGA socket adapter and I am having problems in the reflow of this part. I put no clean paste flux in the solder cups of the adapter then put the BGA part onto the adapter and run
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
.jpg)
