Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw
0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par
Electronics Forum | Tue Sep 26 10:44:28 EDT 2006 | Brad Courtemanche
Hi larry, don't know if you resolved your problem but if machine is picking part three times, rejecting all three but places number fourth your nozzle pickup is misaligned very slightly. During the first three pickups the nozzle is finally seating it
Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Tue May 07 09:33:04 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Wed Feb 11 09:29:59 EST 2015 | bobpan
A reading of 1 almost always means that there is something on the lens or possibly dust inside the unit blocking the laser and tricking the machine into thinking the nozzle is already down when it starts to step from the home 'up' position. Usually i
Electronics Forum | Tue Feb 09 10:01:08 EST 2021 | bobpan
1. The resistor is normally hot. 2. If the machine is crashing towards the front then the system settings need reset. Do this by pressing and releasing the e stop then pressing both front left buttons on the mylar below the lcd screen. Go into the ma
Electronics Forum | Wed Aug 01 09:36:17 EDT 2001 | Pete Barton
Jay, > > I agree with your assement and Chips on > the Quads. I once worked at a shop that had Quads > and DynaPerts(at the time) The perts were > slower(TIME) and required(EFFORT/PEOPLE) more > MAINTENANCE(more effort more people and more > re
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ
