Electronics Forum | Wed Oct 26 05:44:39 EDT 2022 | spacecase
Hello all, I was looking at a Samsung SM421-f component placing machine and it's throwing up an error that was not described in the troubleshooting guide. Anytime I try to move the camera or home it the machine stops and the screen says that a skew e
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Thu Sep 08 15:22:32 EDT 2016 | bobpan
If its a tall part and you are trying to scan it lower than 200 or so...you can have this problem (limit error). Thinking of things to look at.....Is your z-rod spring sticking? Push up on it and it should spring back with NO hesitation...if it does.
Electronics Forum | Thu Aug 25 07:43:24 EDT 2016 | claudea2
We have been having a recurring error on one of our Quad 4Cs. When it picks up the first of 8 47uF SMT capacitor it stops with a limit error. If we do 2 consecutive function 30s, the problem goes away until the next board. The first function 30 re
Electronics Forum | Thu Nov 03 01:39:53 EDT 2022 | spacecase
Thank you for the response, left the machine turned off for a good period of time and somehow the issue solved itself. I was able to calibrate the next day and homing hasn't been an issue. However now I'm having another problem where it gets 4 comple
Electronics Forum | Tue Jun 27 05:28:32 EDT 2023 | ttheis
We powered up our Advantis machine after leaving off for several months. When we powered it up went to zero it we get an error on the y1 axis during zeroing. Command move home: pattern step 0. The y negative limit is hit during homing, the axis then
Electronics Forum | Sat Jul 08 02:10:31 EDT 2023 | unsung
Wipe down and clean the 2 Gold strips on Y Axis and the encoder ( located on both sides of the machines covers must be removed ) Probably has dirt happen to someone who had an old universal 2007 that was sitting outside in the open air for a few day
Electronics Forum | Thu Jul 30 08:46:12 EDT 2015 | hemantp
We are having X-Ray Machine X TEK HMXST-160 The machine is working fine with respect to Interlocking , X-ray on , but not able to zoom and move the Joystick positions ,it is stand only in one position while starting the application we are getting
Electronics Forum | Mon Jul 10 13:08:21 EDT 2023 | ttheis
Thanks, I do recall reading about loading firmware onto some of the VME cards (VRM axis controllers I believe.) I will review this again. I agree that it seems to be some issue with reading axis position after hitting the home switch. The first thin