Electronics Forum | Tue Apr 23 12:17:28 EDT 2002 | binns
I have a couple of questions for you, and a couple of answers. 1. Which model ? (100, IIc, IVc, QSV, QSP ) 2. In reference to how the machine stacks up with Fuji and Panasonic. They have never stacked up. Those families of machines have historicall
Electronics Forum | Wed Jan 17 13:33:23 EST 2007 | slthomas
We're in the process of trying to select a rebuilt, refurbished, or well serviced flexible placer, something that's capable of placing in the neighborhood of 10k and up. We're a high mix low volume shop so easy setups is key. I'd be looking at a MY-9
Electronics Forum | Tue Mar 10 11:23:26 EDT 2009 | vetteboy86
I am setting up a board that is 18.27". In order to be able to reach the whole board, I need to slide the touch stop assembly a few inches further down the slide. After I completed this task, the board will not feed up to the touch stop. The board st
Electronics Forum | Wed Nov 04 07:39:34 EST 2009 | vetteboy86
We have started using an RGB LED and today ran the first boards down our line. I noticed an immediate issue with placing these. I'm using a quad QSP-2. The part sticks to the nozzle. The nozzles are clean. I have adjusted machine handling so that vac
Electronics Forum | Thu Mar 06 17:27:17 EST 2014 | bobpan
Does this happen with just 1 gantry? If so...I would think your encoder in that gantry/axis needs cleaned. I have seen digital i/o cards cause this issue. But usually you will notice this when opening and closing the doors. The head would sometimes
Electronics Forum | Mon Oct 09 13:36:30 EDT 2006 | ppminc
Phil, The QSA-30 was built by Sam Sung, Sold by Quad. Single Head 2 Nozzles around 11K CPH Quad does not support the machine but I believe you can get parts direct from Sam Sung. I am not sure if they have a registration fee. The QSA used Quad made
Electronics Forum | Sat Aug 18 00:49:56 EDT 2012 | audere
When I see this on my QSP2 it is always caused by the nozzle not seating ideally but I tend to set my tolerances really tight. To test mount a nozzle and look at Z height. Now pick up the part (which in my case will suck the nozzle upward due to the
Electronics Forum | Wed Aug 01 09:36:17 EDT 2001 | Pete Barton
Jay, > > I agree with your assement and Chips on > the Quads. I once worked at a shop that had Quads > and DynaPerts(at the time) The perts were > slower(TIME) and required(EFFORT/PEOPLE) more > MAINTENANCE(more effort more people and more > re
Electronics Forum | Wed Mar 25 18:29:47 EDT 2009 | badnewz
My Quad IVc's will also do the same thing. Mine are equipped with CyberOptics scanners, not QuadAlign. The Cyberoptics scanners do go bad and once they do, they get very warm to the touch and at the same time, if the Quad is reset, the theta axis wil
Electronics Forum | Mon Jan 12 14:50:18 EST 2009 | mosborne
A customer of mine has a Quad 4C that will not home in the X. It used to have the problem in the Y then they changed the cards and now that machine will not home in the X when powered up. Anybody have any ideas. I think I know what the problem is, bu
