Electronics Forum | Wed Nov 02 11:27:45 EST 2005 | rlackey
Depends on the actual requirements of the machine & the skill of the operator, but for that sort of money I've seen Juki 570's with a stack of feeders, Versatronics RV4's, older Mydata's, Samsung CP30's, Essemtec, Philips CSM's etc. I even once bough
Electronics Forum | Wed Sep 20 15:25:15 EDT 2006 | lheiss
Hey All, Thanks for all of your help to date. While running the nozzle height test I noticed that the Z-rod is bent. Probably happened after setting the "X closed loop soft home" back to 50 from 384 which was probably why the nozzle slammed into t
Electronics Forum | Wed Nov 09 05:12:43 EST 2011 | bobpan
Motor error 4 is an error that is caused by the machine not reaching a position in a timely matter. Usually its in the x/y axis but also could be z. If you have cleared the mod codes (function 35 shift 7) the machine should home. Usually this problem
Electronics Forum | Mon Aug 20 05:45:18 EDT 2012 | bobpan
To solve your problem....you should do the following: 1. Super Lube the o-rings on the z-rod bellows. 2. Make sure your head to camera calibration and head to head calibration is good. 3. Line up the nozzle changer pocket positions. 4. Make sure you
Electronics Forum | Thu Apr 17 16:55:32 EDT 2014 | bobpan
Hello, The only thing i can think of is the x&y ribbon cables. I know you said they are good but they could have an intermittent break. I would get a spare set and plug them in with the machine at a slow speed setting and see if it works as normal. A
Electronics Forum | Mon Jul 29 13:59:56 EDT 2002 | Garth
Their company isn't new although as I mentioned they have a new line of pick and place machines designed specifically for low to medium volume users. Their web site is http://www.apsgold.com When I attended the Apex show in San Diego last January I
Electronics Forum | Wed Apr 11 00:40:19 EDT 2012 | ngineer
I have a problem setting up the LAE on my Quad 4c. I set it up for 0805, and it seems to work, although it rejects a lot of parts, at least it places "most" of them. I tried setting up on a soic14, and could not get even one to pass. I believe I h
Electronics Forum | Mon Dec 30 21:38:56 EST 2013 | jkoughan
I've got a scary one for you guys and desperately need your help - We just purchased a second Quad 4C and had some communication problems when we first turned it on (we're still working on that issue). To chase down the problem, we decided to start
Electronics Forum | Thu Sep 05 07:14:16 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the suggestions. Sorry I didn't reply yesterday as I'd gone home - I'm in the UK, so I'm guessing there's a time difference. Okay, I found the control to turn off the vacuum verify - it's SHIFT - SWITCH/VERIFY. Makes no di
Electronics Forum | Mon Dec 17 08:58:21 EST 2007 | Frank
You can spend a couple grand on a manual screen printer, or do what I did back in the day: place the board on the work bench and lay the stencil on the board. If you can hold it steady enough you can use a putty knife to apply your paste. For the s