Electronics Forum | Tue May 26 21:27:33 EDT 1998 | Earl Moon
| | | | | I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered a
Electronics Forum | Wed May 27 11:19:34 EDT 1998 | Earl Moon
| | | | | | I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered
Electronics Forum | Wed Jun 02 15:27:27 EDT 1999 | JohnW
| | Hi, | | | | To improve the Design For Manufacturing I am currently looking to write down some design rules that can (and should be) used by our engineering department. | | | | Can somebody help me get started or give some usefull tips on where
Electronics Forum | Tue Sep 28 19:22:48 EDT 2021 | kumarb
Hi. Aside from the good advice above, wish to throw in our experience with our 1809EXL. Had < 200 on-hours and the oven would not melt the assorted fresh paste we sourced from different suppliers. The s/w reported that the set temps were being
Electronics Forum | Fri Mar 23 11:58:01 EST 2001 | mparker
You are mixing long exposed paste back into fresh? How long has your fresh jar been open to the air? You are probably doing yourself a disservice by scavenging the paste (it could have moisture entrapped). Your visocity has definitely changed. You a
Electronics Forum | Fri Mar 23 09:28:46 EST 2001 | PeteC
Well, it's hard to say what it started out as, a smear, splash or ball cause the solder formation on the finger after reflow is spread out ya know. I looked at an archive for possible causes and one was printer operators with paste on their fingers.
Electronics Forum | Fri May 15 10:27:16 EDT 1998 | Justin Medernach
| | We had some failures on an IC package that the manufacturer has put down to moisture inside the package, leading to popcorning. | | This seems a bit odd, the package is a PLCC 84 which is quite thick. I have only seen this problem on thin package
Electronics Forum | Fri May 15 10:41:12 EDT 1998 | Dave F
| | | We had some failures on an IC package that the manufacturer has put down to moisture inside the package, leading to popcorning. | | | This seems a bit odd, the package is a PLCC 84 which is quite thick. I have only seen this problem on thin pac
Electronics Forum | Fri May 15 17:31:04 EDT 1998 | Steve Abrahamson
| | | | We had some failures on an IC package that the manufacturer has put down to moisture inside the package, leading to popcorning. | | | | This seems a bit odd, the package is a PLCC 84 which is quite thick. I have only seen this problem on thin
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411