Electronics Forum | Sat Jun 02 13:57:30 EDT 2007 | rodrigo
Hi all, We have an MCS30 connected to a CP6 and CP4 smt machines. Every time we need to set up a job, the operator has to type the data at the MCS30 terminal. We already have this data in a Windows PC file. I saw a ethernet and several unused serial
Electronics Forum | Thu May 12 01:20:48 EDT 2016 | darby
Check your interface boards and connections. Should be in your manual under "control rack/ board connection/ " then they have the various I/F boards. I don't know the initialisation sequence, but a PC whiz or Samsung should be able to tell you the or
Electronics Forum | Thu May 12 02:17:58 EDT 2016 | cspasol
Thanks Mr. Darby, We already Check All connections of I/F Boards, Restore OS, Change Motherboards and Install Backup for SmartSM files and Install new MMI (SmartSM files). But still same Problem. I have one possible cause in my mind is its MVME3100
Electronics Forum | Thu Aug 21 10:14:57 EDT 2014 | malard
I know my Sanyo machine is no longer made, and the Sanyo connector has died out, but I have an ASYS TRM-03 conveyor that I want to connect up to it, in the manual it references Sanyo for its output format by adjusting a couple of jumpers. However the
Electronics Forum | Sun Aug 20 21:43:19 EDT 2006 | darby
Yes, I agree with guest. Lay it all out with masking tape on the floor. Include the width of feeders sticking out. Confirm the position of power, air, network and smema connections. You may even want to use cardboard layed out on to the floor. You ha
