Electronics Forum | Mon Jun 18 12:14:43 EDT 2012 | dyoungquist
We have a Heller 1707EXL oven. I am assuming the software package that came installed on the computer for the oven is very similar to what you have for your oven. One of the programs in that software package is "ovensetupwizard.exe" You need to
Electronics Forum | Thu Jun 14 13:49:04 EDT 2012 | rodrigo
Hi all, We have two Heller ovens, a 1700SX and a 1700D. The 1700SX has the profiles made so when you load them the zones turn on in sequence. First zone top and bottom are on when the profile is loaded then the next (top and bot) start to turn on as
Electronics Forum | Mon Jan 21 06:58:41 EST 2019 | kiransahu
Without PCB layout, not much would get done. It is a ubiquitous need across industries; Industrial, consumer, military...Everywhere you look, there are chips soldered to PCBs to create a final product for the end customer. But where did we all learn
Electronics Forum | Tue Apr 16 20:38:03 EDT 2024 | digitalshovel
when in assign mode, set npm1 as pass. The condition set will make it pass through to npm2
Electronics Forum | Wed Jun 21 06:10:36 EDT 2023 | madisreivik
Thanks ! I totally forgot that MTU had its own prop file, uploaded it from Flexa and now works fine.
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
Electronics Forum | Fri Jun 23 21:10:29 EDT 2023 | meher
To resolve this issue, you need to ensure that the proper data is stored and transmitted to the MTU. Double-check the communication settings between the machine and the MTU during the startup process. Make sure that all the necessary data is being se
Electronics Forum | Mon Jun 04 12:42:19 EDT 2007 | john_smith
Rodrigo, E-mail me and I will send you a scaned page that tells how to do this step by step.We used to have Fuji and this is our notes on programming and sending jobs down to MCS30. Thanks John
Electronics Forum | Sat Sep 21 17:38:31 EDT 2013 | rmitchell
A PC or computer? Just kidding. Years ago, when I was young you could use a floppy disc and transfer the ascii files at your PC to the disk and then convert them to binary Fuji format on the MCS-16 and MCS-30. You may have to format and then prepa
Electronics Forum | Wed Sep 17 11:13:06 EDT 2008 | daxman
You had mentioned that your volumes will be low? How about the mix? will you be changing over to different products a lot? How many different products will you be running? Will feeder setups be done by the operators or will you have a another departm
