Electronics Forum | Tue May 22 10:33:36 EDT 2012 | swag
In my opinion, the best solution is h-towers or similar dedicated tooling designed for each build. However, a quick cheap fix is to make templates to lay in the bottom of the centernest. If you have access to CAD software, you can print out the ger
Electronics Forum | Tue May 28 18:31:08 EDT 2019 | jlawson
Solder paste flux is main contributor, Lead termination chemical-oxide by products and PCB Plating-Chemicals. Reflow profile would have very limited if not no impact really unless is way off. Paste volume control and Stencil design plays a big part
Electronics Forum | Wed Jul 04 12:35:19 EDT 2001 | davef
I thought I responded this this a while ago, guess NOT!!! Wow, Dano yagot Entek boards that are that old!!!! Coo. Sounds kwazy that you�d end-up with that volume of old boards, but it�s probably one of those deals where correcting the problem keep
Electronics Forum | Wed Sep 27 13:45:35 EDT 2000 | Bill Schreiber
Dear Dreamsniper, A big hidden cost in any cleaning system is the cost of diminished production and rework. I assume you are cleaning the adhesive stencils manually since there is no equipment cost in your formula. Manual cleaning of adhesive sten
Electronics Forum | Tue Oct 26 00:49:42 EDT 2004 | pilengr_tw
Yes, we have an SOP on how to measure. Basically, calibrate the measuring device and measure tension on the 4 sides and one at the center of the stencil. All measurement should be within 30 ~ 50 N/cm otherwise we will not use it and return it to sten
Electronics Forum | Thu Sep 09 12:56:39 EDT 2021 | emeto
Thank you for your reply Djo. What do you consider a normal range tension for 29" stencil on a hard frame? Also I am not sure how I can use micrometer in the middle of 29" stencil to measure the thickness? CAn you please clarify?
Electronics Forum | Sat Jan 11 09:56:15 EST 2020 | jakapratama
There's a lot of parameters to consider in defining stencil life cycle. Average squeegee pressure used, in-process cleaning frequency (auto and manual), physical appearance over time, tension reading over time, and so on to decide how many print cycl
Electronics Forum | Thu Jan 13 13:51:37 EST 2000 | Michael Uganecz
Hello, I'm doing some research on frameless stencils/stencil frames and I'm looking for people's thoughts on them. I'm looking for any and all thoughts/opinions on how well they work or don't work. Some specific areas of interest: tensioning in one
Electronics Forum | Tue Nov 25 05:20:20 EST 2014 | grimus
Could be. I am making overprint to achieve proper amount of solder paste inside hole. Now I am trying to reduce maximum overprint and compensate it with step - up stencil. This could reduce effect that some particles of solder paste are not gathering
Electronics Forum | Fri Dec 09 15:10:55 EST 2011 | davef
Can you use the equipment manual as the basis for learning how to use the machine? Each model of printer has different alignment techniques. We don't have a clue of your model type. So, we'll approach the question from its most basic point. Registe