Electronics Forum | Wed Jul 17 08:21:10 EDT 2013 | ejurentkuff
My boss wants me to look into a 5DX or equivalent equipment. Right now I am in discovry mode. I need to know what's out there and the pros and cons. What type of support I'm going to need (programming, running, etc.) Cost/benefit. Any information
Electronics Forum | Thu Jul 18 16:05:54 EDT 2013 | justinlevine24
Hi Eric, what specifically are you looking to achieve with the 5DX? I can narrow it down for you better if i know what exactly you are going to be using the tool for.
Industry News | 2012-04-17 10:06:22.0
Practical Components Inc., a leading supplier of dummy components, introduces the Practical Dummy Component® version of pre-molded QFN packages.
| http://etasmt.com/cc?ID=te_news_bulletin,11361&url=_print
vehicles.Components were mechanically redesigned to have small metal tabs or end caps that could be directly soldered to the surface of the PCB. Components became much smaller and component placement on both sides of a board became far more common with surface mounting than through-hole mounting, allowing much higher circuit densities and
