Electronics Forum | Thu Jul 12 20:50:37 EDT 2001 | davef
One possible reason no one brought-up "too much paste" is that suggestion has been proffered so many times that it�s in the archives like the layers of sediment making-up Kataden. Another thing [we can argue about this], using home plate apertures w
Electronics Forum | Mon Jul 20 13:47:04 EDT 1998 | MMurphy
:On a dense board, a great way to reduce solderballing is to either; print paste 1:1 with pad size using a 5mil foil, reduce aperture openings by 10% of pad size or change aperture shape to "Home Plate" design. If none of these work on their own you
Electronics Forum | Mon Jul 20 19:31:00 EDT 1998 | Eric
| | :On a dense board, a great way to reduce solderballing is to either; print paste 1:1 with pad size using a 5mil foil, reduce aperture openings by 10% of pad size or change aperture shape to "Home Plate" design. If none of these work on their ow
Electronics Forum | Tue Jun 04 17:21:22 EDT 2002 | jasonfang
I found solderballs are around chip components (on one side of middle area), I checked gerber data, solder paste of aperture on the stencil for these chip components have 5% reduction to solder land on PCB, shape of solder land are square, not home p
Electronics Forum | Mon Sep 19 01:57:28 EDT 2016 | shriram
Hi guys, Problem: Mid chip solder balling. Component affected: 0603 caps only Defect is PCB specific (Meaning only one PCB is affected as the aperture is standard for that component). As a containment I'll give a home plate design for the compo
Electronics Forum | Wed Nov 05 08:49:39 EST 2003 | Axl
You might want to try reducing your stencil aperture by 10% first off; if it still swims try using a home plate design. Also if your profile is going into liquidous to fast, this might cause the swimming as well, check your profile.
Electronics Forum | Wed May 03 16:42:16 EDT 2006 | Silver Sparrow
We run both No-Clean and Water Soluble boards without any problems. We had problems with solderballs, but adjusted the P&P machines not to push the parts into the paste so much. Home plate apperatures help also. The biggest question is if your cus
Electronics Forum | Fri Oct 20 10:15:13 EDT 2006 | wrongway
mid chip solder balls we had that trouble for awhile we went from a 8 mil thick stencil to 6 mil stencil and did some home plate style of cut outs in the stencil for the 1206 caps and resistors it seemed to fix our mid chip solder balls
Electronics Forum | Wed Nov 29 14:49:38 EST 2006 | MS
Any recommendation to reduce solder beads next to 0402, 0603 and 0805 caps and res? What about home plate vs. bow tie stencil aperture design?
Electronics Forum | Wed Nov 29 17:05:15 EST 2006 | slthomas
I have used a 10% area reduction with home plates on 6 mil stencils with good success. If you're using 5 mil stencils you might go with 0 or 5% reduction.
