New Equipment | Cleaning Agents
AQUANOX A4382 is a near-neutral range pH chemistry designed with superior cleaning efficacy with great material compatibility on surface mount assemblies. A4382 most effectively cleans organic acid flux residues at lower concentrations. AQUANOX A4382
New Equipment | Cleaning Agents
AQUANOX A4638 is an engineered cleaning solution designed to remove flux residue from flip-chip and low clearance components on electronic assemblies and advanced packages. Due to low surface tension, AQUANOX A4638 removes water-soluble polar flux re
New Equipment | Cleaning Agents
AQUANOX A4639 is an aqueous cleaning solution designed for hard to clean lead-free, rosin and no-clean flux residues in batch cleaning systems. A4639 provides exceptional cleaning results and protection of metallic surfaces with minimal monitoring an
New Equipment | Cleaning Agents
AQUANOX A4651US is a low pH cleaning solution designed exclusively for use in ultrasonic immersion cleaning systems. A4651US reduces the cavitation threshold, will completely remove flux residues from printed circuit assemblies and is compatible with
New Equipment | Cleaning Agents
AQUANOX A4241 is an innovative aqueous cleaning solution developed for cleaning printed circuit boards and stencils, two (2) processes with one (1) chemistry. A4241 is effective on the toughest of soils while protecting the most sensitive parts from
New Equipment | Cleaning Agents
AQUANOX A8820D is a pour and go engineered micro-cell cleaning fluid designed to remove wet solder paste and uncured adhesive from stencils used in surface mount printing processes. A8820D removes all un-reflowed solder paste using spray-in-air and s
New Equipment | Cleaning Agents
AQUANOX A8830 cleans solder paste from stencil apertures in ultrasonic immersion cleaning tanks. A typical wash cycle using a 10% solution of A8830 at room temperature typically requires less than a 4-minute wash cycle and easily rinses with water, l
New Equipment | Cleaning Agents
CYBERSOLV 141-R is a non-flammable, solvent-based cleaning fluid designed for bench-top cleaning needs removing rosin, resin and synthetic polymeric flux residues from electronic circuitry. CYBERSOLV 141-R is ideally suited for cleaning through-hole
New Equipment | Cleaning Agents
CYBERSOLV 141-R dissolves rosin and low residue flux residues and then readily evaporates after the cleaning application. CYBERSOLV 141-R is designed for bench-top cleaning needs and is ideally suited for cleaning through-hole and SMT electronic asse
New Equipment | Cleaning Agents
CYBERSOLV C8502 is specially formulated to quickly remove all types of flux residues from wave solder fingers, reflow oven surfaces and general electronics production equipment. C8502 is also effective on rosin flux used on fabrication of dissimilar
