Electronics Forum | Wed Apr 18 08:57:45 EDT 2018 | davef
Here is the IPC Standards Tree [ http://www.ipc.org/4.0_Knowledge/4.1_Standards/SpecTree.pdf ]. The design standards that you ask about are over on the right side. I'd guess that the following standards would be a good starting point: * IPC-2221, "
Electronics Forum | Tue Sep 14 13:49:14 EDT 1999 | Earl Moon
| I am looking to find a formula to calculate the resistance of circuit traces based on width | The old MIL-STD-275 became IPC-STD-275 became IPC-2221/2222. Anyway, they had/have simple graphic representations converting AWG standards into equivalen
Electronics Forum | Wed Jul 06 13:22:25 EDT 2005 | Dreamsniper
Can anyone help me on where to find reference for the above info other than IPC2221 as it is not covered by the said standard. I am looking for a proper trace spacing for my lightning protection circuit on my PCB for the following requirements: 750
Electronics Forum | Wed Jul 06 13:22:48 EDT 2005 | Dreamsniper
Can anyone help me on where to find reference for the above info other than IPC2221 as it is not covered by the said standard. I am looking for a proper trace spacing for my lightning protection circuit on my PCB for the following requirements: 750
Electronics Forum | Wed Feb 04 06:26:20 EST 2009 | sachu_70
Hi Peter, The defect you observe during the second side reflow could be caused due to improper Au plating thickness in the PCB fabrication process. You can refer IPC-2221 wherein plating thicknes for ENIG mentions 0.08um to 0.23um for Immersion Gold,
Electronics Forum | Thu Dec 05 02:15:12 EST 2019 | sssamw
IPC 2221B mentions a minimum clearance of 0.5 mm between adjacent holes. A drill-to-drill spacing of 20 mils is a standard value in manufacturer design rules. For small annular rings and pad-to-pad clearance, the minimum via distance is often defin
Electronics Forum | Thu Aug 25 10:32:03 EDT 2005 | davef
IPC-2221A, Generic Standard on Printed Board Design, the base document that covers all generic requirements for printed board design, regardless of materials. From there, the designer can choose the appropriate sectional standard for a specific techn
Electronics Forum | Fri Feb 02 10:16:27 EST 2007 | tglenn
IPC standard 2221A for board design specifies that through hole leads shall be mounted such that there is only one lead in any one hole. Does anyone the reasons for this requirement?
Electronics Forum | Mon Jul 10 20:59:14 EDT 2006 | davef
Dave Try: * IPC-2221 - Generic Standard On Printed Board Design * IPC-2222 - Sectional Design Standard For Printed Board For Organic Printed Boards Our old [euphemistically] friend Earl Moon has written extensively on DFM. Look at his site: http://
Electronics Forum | Thu Aug 09 07:53:16 EDT 2012 | davef
Allowable bow & twist: Together, both IPC-A-600G and IPC-6012B represent the core IPC documents for describing the acceptable and nonconforming conditions that are either externally or internally visible on finished printed boards. IPC-A-600G relies
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100
