Electronics Forum | Sat Nov 23 12:39:18 EST 2013 | joeherz
We installed a Soltec Delta 3 a few months ago and have been trying to run with a VOC free no clean. We're using SN100C in the pot. We are spraying the material and have top/bottom preheat. Evaporation of the water in the flux is a bit of a stru
Electronics Forum | Wed Jul 06 09:07:28 EDT 2016 | davef
Hi Pavel IPC-6012 - Qualification and Performance Specification for Rigid Printed Boards, Paragraph: Solder Resist (Solder Mask) Requirements, Sub-paragraph: Solder Resist Thickness has words to the effect … * Solder mask thickness shall be accordi
Electronics Forum | Mon Mar 11 06:49:42 EDT 2019 | SMTA-Bob
You problem will be related to the part type or the design. Standard 40 or 100 pin QFN or LGA parts are not going to drop due to weight as they are just a few grams. If you send a photo of the PCB pad footprint and the component separately I may be a
Electronics Forum | Thu May 17 07:36:40 EDT 2001 | Bob Willis
Here is a copy of a draft document on PIHR Inspection I have jotted down on a flight to Scotland yesterday, any comments suggestions etc ? I have already most of the photos for the standard but as you know there is nothing in the IPC document it just
Career Center | san diego,, California USA | Engineering,Production,Quality Control,Technical Support
SMT Process Engineer, ISO-9001, IPC-600/610/620/7711/7721, J-STD-001, Thermal profiling, Lean manufacturing.
Career Center | ORLANDO, Florida USA | Engineering,Maintenance,Production,Technical Support
Manufacturing tech/eng for a contract manufacture for 10+ years. Been working in the SMT industry for a total of 20yrs. Have done everything from operator to process work. Most familiar with Assembleon, MPM, DEK, BTU,Electrovert, SLIM-KIC, SUPER-MOLE
.gif)
.png)
