Electronics Forum | Tue Sep 07 16:58:16 EDT 2004 | davef
Au contraire, mon ami. Although there is not "BGA" solderability test specified in J-STD-002A, the Test S can be used to assess solderability on BGA packages. [Joint Soldering Technology Committee ]
Electronics Forum | Thu Jun 16 22:07:16 EDT 2005 | davef
Chris As you imply, testing board and component solderability prior to assembly is preferred. * ANSI/J-STD-002 - Solderability Tests for Component Leads, Terminations, Lugs, Terminals, and Wires * ANSI/J-STD-003 - Solderability Tests for Printed Boa
Electronics Forum | Wed Oct 18 08:00:53 EDT 2006 | davef
Have you tested the solderability of the inbound components per ANSI/J-STD-002, Solderability Tests for Component Leads, Terminations, Lugs, Terminals, and Wires?
Electronics Forum | Tue Oct 31 22:56:23 EST 2006 | davef
So at incoming inspection, what are the results for your "dip & look" solderability testing [IPC/JEDEC J-STD-002A] of the specific problem component?
Electronics Forum | Tue May 29 09:58:32 EDT 2007 | davef
Is the component solderable per ANSI/J-STD-002, Solderability Tests for Component Leads, Terminations, Lugs, Terminals, and Wires?
Electronics Forum | Tue Jul 24 07:57:55 EDT 2007 | davef
It sounds like the QFN component is not solderable. * Use ANSI/J-STD-002, Solderability Tests for Component Leads, Terminations, Lugs, Terminals, and Wires * Contact your QFN component supplier for help * Consider a more active flux, since you might
Electronics Forum | Thu Aug 28 21:39:47 EDT 2008 | davef
Shelf life numbers don't mean dip. Are the parts solderable per ANSI/J-STD-002, Solderability Tests for Component Leads, Terminations, Lugs, Terminals, and Wires? If yes, go solder the parts. If no, get better parts from your supplier.
Electronics Forum | Fri Feb 15 14:45:30 EST 2013 | davef
Yes, the standard applies to things that are soldered. Read this ipc.org/TOC/J-STD-002C.pdf BR, davef
Electronics Forum | Mon May 09 18:05:50 EDT 2016 | davef
Your crystal should meet the requirements of IPC J-STD-002D Solderability Tests for Component Leads, Terminations, Lugs, Terminals
Electronics Forum | Wed Dec 14 19:49:11 EST 2011 | joeherz
Been awhile.... We are in the process of determining where are gaps are for compliance to J-STD-001E and I have a question for those in the know. This section of the standard says the following: ----------- Electronic/mechanical components (includi