Electronics Forum | Fri Aug 23 02:38:05 EDT 2019 | sssamw
Kee OSP PCB dry and sealed with dryer is enough, PCb supplier will tell you how to store it.
Electronics Forum | Fri Mar 06 22:52:16 EST 1998 | Scott McKee
| I will be starting a conformal coating process soon, I am looking for any pointers on | 1) Best method for masking components, tape mask, liqued mask Masking tape or rubber caps will work, the ligued mask is too hard to remove. | 2) Which is best
Used SMT Equipment | THT Equipment
Dear Sir I am looking for following Axial Inserters Machine AVK include LOAD UNLOAD Contact me if you have. OFFER CIF KeeLung
Industry News | 2014-05-13 15:31:32.0
Libra Industries announces the promotion of Bruce McKee from Master Scheduler to Program Manager.
Industry News | 2008-10-07 21:34:23.0
Indium Corporation announces the promotion of David McKee to the position of Key and Direct Accounts Manager for Indium Corporation in Europe.
Technical Library | 2016-02-04 19:11:47.0
In a typical mechatronic manufacturing functional test setup, actual load simulations are usually done by connecting the DUT outputs to power or ground in order to establish either a high or low side driver. Each output is connected with different load and the test will either be sequential or concurrent. At lower power levels, these can usually be managed with general purpose switches. However, when it comes to higher power levels of currents more than 5 amps, such switching and loading might pose a greater challenge. Furthermore, critically in the manufacturing line, the tradeoff between cost and test time would have a great influence on the test strategy.This paper will present some key points to design a cost effective high power switching and load management solution.
SMTnet Express, February 4, 2016, Subscribers: 24,087, Members: Companies: 14,964, Users: 39,872 Make the Right Design Choices in Load Switching and Simulation in a High Current and Mechatronic Functional Test Derek Ong, Lok Teng Kee, Chuah Rhun
.gif)
winsouce.jpg)