Electronics Forum | Tue Oct 22 14:43:20 EDT 2019 | kathylci
Looking for someone to speak with regarding a Koh Young 3030VAL. Want to find out some information on the ease of programming for this unit. Any help is greatly appreciated! Thanks- Kathy
Electronics Forum | Sat Nov 09 14:15:18 EST 2019 | linux
Perhaps I can help you out, have experience with kohyoung Spi and AOI
Electronics Forum | Thu Mar 24 23:41:40 EDT 2022 | glasscake
Another oddity, when I unplug the PCI1/2 cables and cycle power I still get the same error.
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Mon Mar 28 23:52:08 EDT 2022 | glasscake
Seemed to have fixed it. When reassembling the gray PC I noticed the motion controller card can be pushed into the PCI connector rather deep. once i raised it up and only pushed it as far as the washer would have it go in it started to work again. I
Electronics Forum | Thu Feb 14 03:49:56 EST 2019 | dimamalin
Thank you , it going to be very useful
Electronics Forum | Thu Feb 14 02:36:55 EST 2019 | dimamalin
Hello everybody,if someone have KY-3030 programming manual Instruction pdf ,please send me to my mail dima_ma@usr.co.il Thank in advance Dima
Electronics Forum | Wed Jan 16 12:18:35 EST 2008 | mscalzo3
We looked into the same issues last year, and we decided on a Koh Young 3020 (table-top) that is running Koh Young 3030 (In-line) software. Our decision was based on a 1-year research process that included data from both our customers that were usin
Electronics Forum | Thu Feb 14 03:38:51 EST 2019 | bane016
I have and will send..but i'm not at job right now...tomorow will send.. KY is easy to programing if you have gerber data...i can write here steps how to programing
