New Equipment | Cleaning Agents
LONOX® L5611 is a solvent-based cleaner for misprinted boards and stencils. It is effective on a wide variety of flux, solder paste and uncured adhesives. Easy to use, L5611 is intended to be diluted with water and effective at ambient temperature t
Industry News | 2010-01-22 21:46:55.0
Minneapolis, MN - The SMTA is pleased to announce several new online presentations coming up in February. In response to industry-wide budget cuts and travel restrictions, SMTA has committed to increasing its online programming to better accommodate member needs for technical exchange.
Industry News | 2021-08-13 12:58:35.0
The SMTA Capital Chapter, Carolinas Chapter and Philadelphia Chapter are excited to host their first ever tri-chapter event, Mid-Atlantic Advanced Learning Session - Failure is Never an Option, A Deep Dive into Failure Analysis.
Technical Library | 2014-03-06 19:04:07.0
Over the last few years, there has been an increase in the rate of Head-in-Pillow component soldering defects which interrupts the merger of the BGA/CSP component solder spheres with the molten solder paste during reflow. The issue has occurred across a broad segment of industries including consumer, telecom and military. There are many reasons for this issue such as warpage issues of the component or board, ball co-planarity issues for BGA/CSP components and non-wetting of the component based on contamination or excessive oxidation of the component coating. The issue has been found to occur not only on lead-free soldered assemblies where the increased soldering temperatures may give rise to increase component/board warpage but also on tin-lead soldered assemblies.