22510 PART 22705 PART 10114KX PCB ASSEMBLY 10115BP PCB ASSEMBLY 101-4 RACK CONSOTROL FLUSH MOUNT 4UNIT MOUNTING 111-A INDICTAOR 111-A-L INDICTAOR PNEUMATIC CONSOTROL HIGH-LOW ALARM LIGHT 121003D D ETECTOR 122-FE RECORDER 2PEN PNEUMATIC PROCES
Electronics Forum | Thu Feb 20 00:51:42 EST 2003 | Joe
We are running an RMA flux (Kester 1515). Changing the angle didn't help any so we're back at 6 degrees and placing an order for the lambda nozzle changeover. Are you currently running the debridging knife?
Electronics Forum | Sat Feb 15 15:39:53 EST 2003 | Joe
I have the identical machine and setup as you with the same issue(s). I looked at setting up for N2 but am choosing to retrofit to a standard lambda nozzle setup. If you are soldering bottom side SMT parts or other challenging assemblies, N2 may ma
Electronics Forum | Thu Nov 13 14:29:17 EST 2014 | proy
I will soon be filling an electrovert solder module which is only going to be running one (lambda) nozzle/pump. this leaves quite a bit of solder volume I am going to have to put $$ into. Has anyone here used iron bars or spacers or bricks or other
Electronics Forum | Fri Jan 31 14:33:37 EST 2003 | joeherz
Dave, I do have the mechanical drawings but no electronic versions. After looking at the cost of setting up for N2 I decided against it for now, BTW. If you think about it, having an air knife on this nozzle would tend to negate the negative effec
Electronics Forum | Mon Mar 13 14:41:22 EST 2000 | Boca
By Hot Air Knife I assume (leave it alone Dave F.) that you mean a debridging knife located at the exit end of a wave solder machine. Russ is right, they are not a good substitute for a good process, but once the process (w/o HAK) is developed, it
Electronics Forum | Mon Mar 13 14:45:01 EST 2000 | Boca
By Hot Air Knife I assume (leave it alone Dave F.) that you mean a debridging knife located at the exit end of a wave solder machine. Russ is right, they are not a good substitute for a good process, but once the process (w/o HAK) is developed, it
Electronics Forum | Mon Mar 13 14:41:22 EST 2000 | Boca
By Hot Air Knife I assume (leave it alone Dave F.) that you mean a debridging knife located at the exit end of a wave solder machine. Russ is right, they are not a good substitute for a good process, but once the process (w/o HAK) is developed, it
Electronics Forum | Mon Mar 13 14:45:01 EST 2000 | Boca
By Hot Air Knife I assume (leave it alone Dave F.) that you mean a debridging knife located at the exit end of a wave solder machine. Russ is right, they are not a good substitute for a good process, but once the process (w/o HAK) is developed, it
Electronics Forum | Tue Jan 28 18:38:36 EST 2003 | joeherz
Mike, I've tried the high side of the flux preheat spec with no success. I did just get off the phone with Electrovert tech support...... Get ready. This machine is configured with a Contour Plus N2 nozzle. We are not running N2. According to M
.png)
