Electronics Forum | Thu Feb 19 19:34:52 EST 2004 | Tom B.
Jim, There are 2 thoughts to this technology. SMDP (Soldermask Defined Pads) Can achieve more uniform opening of the land, yet as you know Regisration shift of mask can become a problem. Also there has been debate as to whther SMDP cause crack p
Electronics Forum | Wed Apr 28 12:18:04 EDT 1999 | Scott McKee
| Hello all, | | I read about Steve's headache a few articles back and I'm really interested by his tip. However, I'm still wondering why square apertures release solder paste better than round ones. For the same volume of paste, the surface area
Electronics Forum | Wed Apr 28 11:16:45 EDT 1999 | Steve Gregory
Hello all, I read about Steve's headache a few articles back and I'm really interested by his tip. However, I'm still wondering why square apertures release solder paste better than round ones. For the same volume of paste, the surface area of th
Electronics Forum | Fri Jul 30 17:13:30 EDT 1999 | Dave F
| | | Looking for solder paste specification limits which have reliability data to support them. Currently, we are looking to define the min/max volume necessary to ensure a good joint on CBGA, PBGA, and Micro-BGA's. Any information will be greatly
Electronics Forum | Mon Aug 28 12:41:35 EDT 2000 | JAX
MoonMan, I'll take a crack at the list. Feel free to answer the ones I don't! 1. Solderability is a parameter which indicates how well a component can be soldered. As far as Solder Termination Coatings go, here are some up�s and down�s of a few. Ha
Electronics Forum | Thu Aug 24 15:12:29 EDT 2000 | Earl Moon
I don't entertain the forum like JAXSUN. I never have played games but for some humorous insights. I, when participating, never complained until management provided only more incentive to advertisers than forum members. That said, the following is a
Electronics Forum | Wed Dec 22 14:21:13 EST 2004 | James Dornan of APE Inc
A little late but if this subject is still of interest the following paper from APE may be of interestwhen considering IR to Air Bath: HOT AIR versus IR and other convection Rework Systems HOT AIR is the most popularly chosen method of rework in th