Electronics Forum | Tue Mar 12 09:24:47 EDT 2013 | bobpan
If you edit the sequence on the hht.....to fix your problems...you then have to upload the data to central controller. If you are not doing this....you are overwriting the data on the machine with bad data everytime you download to the machine. The l
Electronics Forum | Tue Feb 09 09:18:13 EST 2010 | davemacnemo
Machine installer gave me some tips and a run through the software. Everything worked just fine. First solo attempt to run product that we started with gives L305 SoftLimitOver... error after picking first components and passing over camera. Additio
Electronics Forum | Fri Feb 01 19:12:18 EST 2013 | marcelorotofrance
Hi, I have a QUAD 4C mk2. I taught pickups and places from HHT. If I test them individually (RUN STEP PICK/PLACE etc...) before building the sequence, everything runs ok. After the sequence was built, everything goes wrong. Every PICK or PLACE ends i
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
Electronics Forum | Wed May 02 09:14:08 EDT 2007 | stefi
Hi, We have a very annoying problem with a Philips Orion 2 SMT machine. It displays the error message "Second Limit Over" a few times per shift and it's impossible to make the machine work again unless it is turned off from the mains. It stops in th
Electronics Forum | Wed Feb 23 22:56:46 EST 2011 | jeffr
When I enter the "Setup Table Contact" menu, then press "Load PCB" the squeegee head should move to a mid position that I can set the squeegee height, but instead it moves the squeegee head to the front limit and displays a red error message about th
Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
Electronics Forum | Wed Oct 31 03:35:41 EDT 2007 | meritajs
Hello All, We have problem with one from our YAMAHA SMT mounter. It had weard defect. It gives error message"soft limit X over" when next step must pick up with head3. But all coordinat for next component do not exeed movable range. This failure happ
Electronics Forum | Mon Jan 08 01:47:35 EST 2007 | fpcb
hi to all, I have a old MPA-80 machine. I use it for simple boards without problems till now. For a more difficult board I have tried to use command "M801", I think that I have done everything right but I receive a error-message like " x(-)soft
Electronics Forum | Fri Aug 31 16:30:27 EDT 2007 | gmoritz
> > you may wish to do program off-sets per rotation ... I responded: > > You went over my head with that one. ... Steve Thomas helpfully added: > ... can reach that screen with SH SET command, Since I have not yet located a programming manual
