Electronics Forum | Mon Dec 12 14:05:45 EST 2005 | derengmao
I tried to use the Fixed Camera to inspect TSOP, however, I got either "UPPER SIDE END PIN ERROR", or "Missing Group:1". I have never had a parts getting recognized. I adjusted all parameter possible: Light, size, width, length. By using Dispaly Par
Electronics Forum | Thu Feb 15 17:00:37 EST 2007 | bvdb
Hi Jerry, Thanks for coming to my aid again. I have tried your settings of 10% for Lead check and pitch limit but still rejects the part. The vision image looks clean on the display. On one of the last trials I noticed that the part was picked up
Electronics Forum | Tue Feb 04 03:22:15 EST 2020 | tamasmagyar
You can do some changes on the fly on the machine, but is very limited. Like deleting a board from the panel, modifying offset, modifying fiducials etc. The thing is, I have issues with the programming interface, because the crashes and errors I get
Electronics Forum | Sun Jun 07 11:47:10 EDT 2020 | saduquette
Hi, I went to run my IVC yesterday and it got a Motor Error on first pickup. Pressing Enter showed Z:-27:0 So according to the manual that means the Zaxis was commanded to go to -27, but the limit is '0'. I tried a Function 3 on that pickup and
Electronics Forum | Mon Oct 16 16:30:27 EDT 2023 | yannick_herzog
@MagyarT the error occurred across multiple PCBs throughout the entire job. So, for example, the issue isn't limited to just the first printed one but spans the entire duration. At what dimensions would you recommend a division? The apertures on the
Electronics Forum | Mon Dec 02 12:52:40 EST 2002 | slthomas
We're trying a selective soldering pallet for the first time with mixed reviews. Are solder balls a prevalent problem with this process? Most of them seem to correspond with pallet wall locations....is it too much turbulence from the rotary chip wav
Electronics Forum | Mon Apr 28 18:34:17 EDT 2003 | Brian W.
We typically do not try to pick up and hand placve chip resisstors and capacitors. The risk and cost is too high for components that are a penny or less. We take into consideration that on many of our components, someone will have to test them to v
Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search
Electronics Forum | Thu Aug 27 05:49:53 EDT 2015 | alexeis
Hi, To calculate both values you need: 1. Theoretical speed of all machines (Printer, SMT, Reflow). This is a basic upper limit value of speed. Use it for calculate a maximal theoretical values as upper limit. For real values, read next. 2. High r
Electronics Forum | Wed Oct 10 17:47:49 EDT 2007 | jmelson
Does it give any more info about the error? Is this in the stage after you've hit run, it says "initializing" and it is counting up on the screen? Usually it gives a little more info, although it can still be cryptic. I have run into it stopping w
