Electronics Forum | Wed Feb 12 14:14:42 EST 2020 | alvarez94
I am running a MYDATA MY19 machine.the problem is that the first 2 hours after turning on the machine it does not work throwing the following error: "transducers do not agree". After approximately 1 or 2 hours the machine starts working normally. T
Electronics Forum | Tue Jul 05 22:10:42 EDT 2022 | nellegaard
I am currently trying to setup a used MyData My19 machine and am currently having issues installing tools getting errors such as failed to pick up tool and Z force sensor failed. I have tried to clean the tool pickup area as well as clean and lubrica
Electronics Forum | Wed Feb 12 14:39:23 EST 2020 | SMTA-Alex
Do you have a photo of the actual error?
Electronics Forum | Wed Feb 12 14:44:56 EST 2020 | alvarez94
Thanks for responding, this is the photo of the error that appears on the screen
Electronics Forum | Wed Feb 12 14:53:21 EST 2020 | SMTA-Alex
Looks like an X-belt problem. is it tensioned correctly, not too loose or too tight? Or the X motor is acting up.
Electronics Forum | Wed Feb 12 15:15:10 EST 2020 | SMTA-Alex
Not really, just eyeball. Does it look too loose or feel too tight. Is it lubricated properly, is there enough grease on the sprockets? Also, check the ribbon cables. They might be damaged.
Electronics Forum | Thu Feb 13 16:23:07 EST 2020 | alvarez94
I checked it and there is no problem with the lubrication the cables are in good condition. The band feels a little loose I will try to make the adjustment to see if that is the problem.
Electronics Forum | Mon Dec 07 09:43:09 EST 2009 | kpm135
Just to throw my two cents in the MY19 could be slower than the other my machines due to the greater distance the head has to travel to pick up and place the components.The longer distance could also account for extra wear and tear on the motors and
Electronics Forum | Wed Jun 04 08:54:46 EDT 2008 | sys_steven
We just had an issue where only slots 9 and up advanced on any feeder, an slot 2 advanced all the time. Slot 1 and 3-8 would not advance in any position. We replace the IC's at U12 and U13 on the M1 card, now slot 1 is the only one not working. We
Electronics Forum | Sat Dec 05 22:08:21 EST 2009 | casmt
MY9 - 19 are all the same machines. The frame is only bigger. With the 19 you can get up to 256, 8mm feeders if it has the stand table. Ocourse that is an advantatge it can handle large boards with a big table. I have used Mydata a many companys. A
