Electronics Forum | Wed Feb 12 15:11:29 EST 2020 | alvarez94
I was consulting the manual of the machine and to measure the tension of the x belt I need a frequency counter and two prisms but I don't have these tools, is there any other way to measure the tension?
Electronics Forum | Thu Jun 07 10:03:19 EDT 2012 | anton99
Hello, I recently joined this site and this is my first post. After searching through the existing threads I decided to post my question. I work at a CCA manufacturing facility that recently added a SMT line. We used to have one line and now we are r
Electronics Forum | Thu Jun 07 12:00:19 EDT 2012 | gnus
We've had similar issues in the past when we were running a My19 and a My12. What we decided to do in the end was allocate just enough parts needed for the first job (taking into consideration reject rate) so when another job comes around needing tha
Electronics Forum | Thu Sep 08 18:10:09 EDT 2022 | mt396596
We just went through a similar issue with our MY12E. Make sure your Midas vacuum system is working, check your Midas Z friction. Also verify the Centering unit centering band. You can swap your MOTZ and MOTC to rule out the card. The tool install t
Electronics Forum | Mon Mar 30 13:01:58 EDT 2020 | midast
Thanks Bruce, you are right. When thinking about it that might actually be the issue. I can't by pass the battery pack, unfortunatly ( at least not in my model) I have ordered new batteries that will arrive in a few days. After I removed and put b
Electronics Forum | Tue Jun 08 22:30:05 EDT 2021 | vtdivtecs
So I am having a little trouble with my mydata MY19. its an older machine picked up used and its had its quirks. recently we tried to start adding electrical verification to our workflow, and had to disable it as we were getting intermittent bad pa
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t