Electronics Forum | Thu Sep 03 01:14:40 EDT 2009 | sachu_70
Yes, it is important to ensure blade pressure over stencil is uniformly distributed across the entire length of blade. Such is possible only if the stencil is firmly supported from below, which during printing is done by the presence of the PCB itsel
Electronics Forum | Sat Feb 05 14:51:08 EST 2000 | Bill Petlock
Casimir, The Q and other lead trimmers work extremely well if properly used. Blade life is directly proportional to to the height of the cut. There are a few factors that are very important in trimming. You are working with a solid carbide blade whi
Electronics Forum | Thu May 10 19:22:06 EDT 2007 | joeherz
We have a board that requires a .015 - .035" finished lead length which requires us to do mass lead trimming. To this point we've performed this activity on parts with straight leads. We're looking at going to an axial auto-insertion process (outso
Electronics Forum | Fri May 11 07:38:14 EDT 2007 | tombr
It is possible to vary the length of lead during auto insert. However, it requires software and mechanical adjustments. Universal equipment allows small changes via software program for lead length. To change angle of clinch involves a mechanical a
Electronics Forum | Thu Jul 19 22:31:42 EDT 2001 | Pete
Received an info that the longer the oven the higher the throughput. What's the formula when calculating oven throughput ? say, i have the following: Oven Length : 266 cm Conveyor Speed: 29cm/min PCB Length: 29 cm Gap per Board: PCB Length x 0.5
Electronics Forum | Mon Apr 04 08:48:33 EDT 2005 | jimih280
that depends on clinch direction, length, and angle. .200" hole center to center is usually safe for all automatic insertion equipment.
Electronics Forum | Wed May 13 17:46:09 EDT 2009 | cusackmusic
Does anybody have any recommended Clinch/Length values for: 1/4W Resistor 1N4007 Diodes 3W Resitors (A bit bigger than 1N4007 leads). Thanks, Jon
Electronics Forum | Fri May 15 22:06:10 EDT 2009 | jrr3434
I use a clinch of 5 and a length of 3 for 1/4w and thicker leg diodes probably a 7 and 5. You really just have to play with the machine it figure out what works best for your application.
Electronics Forum | Tue Feb 23 12:49:10 EST 2010 | gregp
Dilbert is correct. The CS-400E machine is the machine of choice. The component insertions are light guided, the components are automatically presented to the operator and the leads are automatically cut and clinched at programmable lead length and
Electronics Forum | Mon Oct 26 16:01:33 EST 1998 | tom Gervascio
| | I need some info on how to stop the bridges I'm having on | | radial and axial parts that are in the same place on every board. I'm also having problems with sot-25 bridging. I'm using a Electrovert E-pak. I tried leveling the machine,solder pot
.jpg)