Electronics Forum | Tue Apr 19 10:09:33 EDT 2016 | swag
Try a nozzle changer teach. Machine will look for fids on the changer block. If that doesn't work, clean the rubber seals in the bottom of the block. No alcohol - dries them out. Might need to replace them if they are dry or cracked. Clean your
Electronics Forum | Tue Apr 19 12:38:00 EDT 2016 | ttheis
Looks like that did it; I put another nozzle in hole 5, set the configuration and machine dry-cycled properly.
Electronics Forum | Tue Apr 19 11:30:50 EDT 2016 | ttheis
Hi Swag, Thanks for the suggestions. I did perform a changer teach on both changers successfully which resolved minor mis-alignment issues but not this problem. You can see in the photo that there are two open holes (5&6)and it is trying to drop a n
Electronics Forum | Tue Apr 19 03:19:03 EDT 2016 | ttheis
Hi All, I have been running into an issue where my gsm is not leaving an empty nozzle hole in changer 1 and is leaving two open in the other changer. The machine is attempting to change one of the nozzles 5-7 and leaving one open so no vacuum builds
Electronics Forum | Wed Apr 20 10:16:21 EDT 2016 | ttheis
Yeah, I think it has to do with both changers being owned by the one head. If each changer was owned by separate heads then they would each need an open hole.
Electronics Forum | Wed Apr 20 10:04:45 EDT 2016 | swag
Yea! Sounds familiar that you'd need to do that. I haven't run GSM for a long time but sounds like something we had to do at some point.
Electronics Forum | Tue Jun 09 09:04:58 EDT 2015 | lisaaci
Its not picking up the nozzle from the changer. It either doesn't at all, or leaves the nozzle partially in the changer.
Electronics Forum | Tue Jun 09 14:10:41 EDT 2015 | duchoang
Last time I used Topaz X2 was 5 years ago. Correct me if I'm wrong. There are some reasons: -Head dirty so machine thought there was nozzle on head already. -Nozzle changer/ Nozzle position offset. -Something jammed and nozzle changer can not go all
Electronics Forum | Tue Jun 09 04:49:12 EDT 2015 | vinitverma
Is the machine not picking up nozzle from the nozzle changer or is the head 7 not picking up any components? Or is the mis-pick rate too high?
Electronics Forum | Wed Jun 10 00:34:40 EDT 2015 | vinitverma
I understand from your post that the head does go to the nozzle changer intending to change the nozzle but sometimes it entirely fails to pick up the nozzle and sometimes the nozzle gets picked up a bit but gets stuck in the nozzle changer. This mos