Electronics Forum | Tue Sep 19 14:52:40 EDT 2006 | bobpan
Grease every 2-6 months depending on the hours used. Dont overgrease.....and make sure you wipe off all excess grease after lubing because the grease always tends to get into the horseshoe sensors and then you will get motor error 4's untill you die!
Electronics Forum | Mon Jan 29 15:49:08 EST 2007 | rmitchell
Hi, Our Fuji CP65 nozzles are jamming in the up position. Mostly on caps and resistors, the .7mm (0402) and 1.0mm (0805) and 1.3mm (1206) sizes. They seem to be catching internally where the little peg slides down the slot. If you twist them they
Electronics Forum | Fri Oct 12 16:29:21 EDT 2007 | dyoungquist
When we bought our Heller reflow oven, the installation technician recommended using Oberon chain lube part # 680784(0) when we needed to purchase more oil for our chain. I just went to the oberonlube.com website and could not find that part number.
Electronics Forum | Tue Nov 06 07:37:02 EST 2007 | cyber_wolf
Does anyone out there have a method of cleaning CP6 shaft clutches that is "easier" ? I am not a fan of just pulling the shaft down and wiping it out. I like to take them apart and clean/lube them. It is a pain to get the crowns back on without rip
Electronics Forum | Sun Feb 03 11:10:13 EST 2008 | fastek
Pretty simple explanation really as it's happened to equipment I have sold and sent to Asia. If the paperwork on the importer's side of the transaction isn't up to snuff or they haven't paid off the right guy to get it in the country, the machine w
Electronics Forum | Wed Jul 02 16:58:40 EDT 2008 | jmelson
If these are similar to the earlier CSM feeders, there are several things to check. The cover plate that holds the tape on the sprocket can be adjusted slightly by eccentrics to accomodate thicker tapes. It the cover is too tight, there will be bin
Electronics Forum | Tue Jul 07 07:08:23 EDT 2009 | daxman
During a service call, We had a FUJI guru tell us that Biral was actually not a great lubricant for LM rails or rust prevention because it thickens and gums up quite quickly, which is true. His recommendation was to use TFL-50 wet lube. We've been u
Electronics Forum | Mon Mar 16 06:12:32 EDT 2015 | bobpan
The first thing to do is to change the z-rod. Sometimes a very old z-rod spring will weaken causing it to reject many parts. If it only rejects parts after a nozzle change....you may need to put some super lube grease on the O-rings on the bottom of
Electronics Forum | Sun Dec 10 22:38:04 EST 2017 | jmelson
I have an old CSM84 with the brush motors, model PA130620. I had a few intermittent feedback errors, now they have gone solid. But, I found slowing the machine to 85% lets it run without the error. So, I'm thinking there may be drag on the axis. T
Electronics Forum | Wed Apr 20 18:06:37 EDT 2022 | kumarb
For future readers - just needed a little bit of lube. Many thanks to Michal & the staff @ Trans-Tec (USA) for their excellent support, as always. Please see attached. For our (dated) machine, the black dial would turn only after hitting the gym