Electronics Forum | Wed Dec 20 04:08:09 EST 2006 | ungun
Sorry for the late reply. I use glue dispenser machine juki kd-775. It have dispensing diameter confirmation unit, but dispensing test tape can be hold for 2 to 3 days a roll if the output 300 pcs pcb with average glue point 100 per peace. Beside, i
Electronics Forum | Fri Sep 06 06:11:40 EDT 2013 | fnorradd
Hi All, We have purchased an Ersa Versaflow selective solder machine, and I am looking in to profiling upon the machine. We currently have a process for profiling our wave with a WaveRider system, this we use to gauge that the machine is set up cor
Electronics Forum | Mon Oct 09 18:40:43 EDT 2006 | darby
Seeing you are already using Quad; I'd look at a Samsung CP-45V. I believe your feeders will be compatible but please cheeck to make sure! These are a six head, on the fly machine that will do just about anything you want apart from gripper applicat
Electronics Forum | Mon Oct 09 07:50:22 EDT 2006 | quad
We currently run two Quad IVC's (we are very pleased with them) and two Versatronics for simple small volume batch work. We now need an additional machine capable of placing components at least three times as quickly as a IVC. We don't do anything ve
Electronics Forum | Mon Aug 04 21:37:29 EDT 2003 | davef
We loose power all the time. So, we have a UPS the size of a four of cases of beer on our telephone system. On placement machines, most people opt for an orderly machine shut-down, rather than completing the program, but you can do it either way.
Electronics Forum | Mon Oct 09 13:36:30 EDT 2006 | ppminc
Phil, The QSA-30 was built by Sam Sung, Sold by Quad. Single Head 2 Nozzles around 11K CPH Quad does not support the machine but I believe you can get parts direct from Sam Sung. I am not sure if they have a registration fee. The QSA used Quad made
Electronics Forum | Sat Jun 05 13:38:22 EDT 2021 | ppcbs
For Linear Tech LGA's we solder bump the LGA using a .30mm solder ball then reflow with a tacky flux. This will provide a void free solder joint and adds a little height to the solder joint in case you use a flux that you want to clean from under th
Electronics Forum | Mon Mar 18 10:33:27 EDT 2013 | babe7362000
It is not the feeders having the issue. The tape on the strip of parts does not want to pull up easily. I just wondered if anyone else out there is having the same issue. Thanks for any feedback.
Electronics Forum | Sat Feb 03 03:03:11 EST 2018 | buckcho
Hello, Mr. Evtimov is right. What kind of pick and place machine do you have? Implementing the MSL into a datamatrix barcode is the first step. Then you might want to use your machine's software solution (if possible) to track this. Another solution
Electronics Forum | Fri Jul 04 19:17:37 EDT 2014 | andrespena
Hi (I don't know if this forum is the best place to post something like this, but I don't know of other places on the internet, so... sorry if I'm in the wrong place) Might there be an easier way to add components (e.g. computer chips) to a circuit
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.gif)
