Electronics Forum | Thu Aug 26 07:12:23 EDT 1999 | Mika Johnsson
| | I rotated my PCB -90 degrees. Now what's the formula to calculate the X-Y Coordinates of my component CAD Data? | | | | Thanks, | | | Not very difficult | | (Subscripts n = new, o = old) | | Assuming the same origin: | | Yn = Xo | Xn = -Yo |
Electronics Forum | Fri Aug 27 07:28:26 EDT 1999 | Brian
| | | I rotated my PCB -90 degrees. Now what's the formula to calculate the X-Y Coordinates of my component CAD Data? | | | | | | Thanks, | | | | | Not very difficult | | | | (Subscripts n = new, o = old) | | | | Assuming the same origin: | | |
Electronics Forum | Fri Jan 16 07:48:29 EST 2004 | Mika
We usually program the components in the component database with pin 1 in the lower left corner. Then in the feeder database we set the component orientaion to 270 deg for Tray feeders(turn the tray in the feeder 180 deg) and "tube" feeders. For tape
Electronics Forum | Fri Jan 16 07:06:47 EST 2004 | Mika
Component manufacturer often have recommendation for pad layout and process setup. This should be used as a guideline to help You to set up the process. Exactly what type of component is this, uBGA? We populate 64 I/O uBGA's on our pcb's with 0.3 mm
Electronics Forum | Sun Oct 30 03:55:43 EST 2005 | mika
I apologize for my poor english. First: "Double sided sticky tape" is excellent for various reasons; right/left?. Second: NPI? Don't hesitate, If You feel that a certain machine in Your line cofiguration don't place certain/certain's components on th
Electronics Forum | Mon Aug 21 04:20:49 EDT 2006 | Rob
Hi Mika, I used to work for the largest chip cap manufacturer in the world, and by far the largest problem we would see was cracking due to incorrect z height adjustment on Chipshooters. It can also cause solderballs and bad joints by displacing th
Electronics Forum | Thu Sep 14 06:45:11 EDT 2006 | Rob
Hi Mika, We had roughly the same set up - AP27 -CP6x2, GSMx2, VIP98 & we ran the thin boards with durastone routed pallets. If you route out a 0.4mm pocket on the pallet and either use kapton tape/high temp masking tape/ or 3M spraymount to hold
Electronics Forum | Sat Mar 24 03:06:55 EDT 2007 | aj
Hi Mika, We came across some difficulties with this type of device a couple of years back . After the proto run we needed to touch up the outside fillets to get stability and product to pass test. ( even though the manf. stated that there is no fill
Electronics Forum | Sat Sep 22 02:14:08 EDT 2007 | mika
Another thing to make sure of and the vision calibration system will fail if this is out of range: Use a magnet foot stand micrometer and measure the spindle run outs. First remove the nozzles and nozzle adapters, then put the adjustable tip (I dont
Electronics Forum | Fri Oct 05 21:29:43 EDT 2007 | mika
Hussman, I don't understand the last sentence of yours "but far from where this thread was going". What do you mean with that? I was just trying to give "Novaman" some infos. The fine old equipment You use from the old -20:s or so, is probably just a
