Electronics Forum | Tue Sep 09 14:49:13 EDT 2008 | ksrsr
We get our component stencil for this type of rework from Mini-Micro Stencils. We use a Air-Vac rework station and we have no issues at all.
Electronics Forum | Thu Dec 20 16:32:54 EST 2007 | gsala
Over here in Eurolandia the following Allois are running like a piece of cake. http://www.krepro.no/tinn_pasta_fluss/NiGe-Stangtinn.pdf It is FUJI patent Formula, sold in Eurolandia by FELDER Germany Really a good help in the Lead Free Wave Solder
Electronics Forum | Fri Aug 13 08:14:38 EDT 1999 | Peter Barton
| Ladies and Gentlemen, | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav tremendous
Electronics Forum | Thu Feb 28 16:40:04 EST 2002 | liviuj
>Dear SMTneter, >>I am loonkig for some information about how to rework a >>BGA. >>Some technical info explaing how to put solder past >>manualy, soldering manualy, tips and so on. >>Where can I find something about? >>Thanks in advance >>Marcos Hi
Electronics Forum | Sat Jan 17 15:06:54 EST 1998 | Stefan
| Is there any way to implement SMT at home? | I want to assemble a prototype board of mine. | How can I hand-solder a 208-pin 0.5 mm lead | pitch PQFP -- lead-by-lead (the usual way), | or side-by-side (partial heating method)? | Alas, no SMD rework
Electronics Forum | Mon Jun 17 19:10:04 EDT 2013 | hegemon
You have not mentioned exactly how the BGA was reflowed onto the board. Was it sent through the oven again after the mini-stencil, or was it heateed up and reflowed using a BGA rework station, or other hot air device?? From the sound of it (outside
Electronics Forum | Mon Jan 26 04:48:48 EST 1998 | Grant Petty
| Is there any way to implement SMT at home? | I want to assemble a prototype board of mine. | How can I hand-solder a 208-pin 0.5 mm lead | pitch PQFP -- lead-by-lead (the usual way), | or side-by-side (partial heating method)? | Alas, no SMD rework
Electronics Forum | Tue Aug 10 13:05:57 EDT 1999 | ScottM
| Folk's, | | I'm looking for some helpful suggestions for reworking wave soldered bottomside components that have been glued. | I'm not a fan of the twist and break approach and as some of them either have a double dot or a slot configuration this
Electronics Forum | Mon Jun 07 10:52:04 EDT 1999 | Brian Wycoff
| | | | Where I can find some informations about repairing of SMT boards? | | | | | | | | Thanks | | | | | | | | Marcos | | | | | | | A first place to start is IPC's 7711 and 7721 encompasing repair, modification, and rework procedures. | | | |
