Electronics Forum | Mon Feb 02 12:26:24 EST 2004 | kauer
cd{space}mint. At the mint directory type C:>MINT/load. Re-start using ctrl+alt+del when mint is finished loading, it will sayC:MINT/. Note: If your Machine comes back to life, Do Not turn off main power until You can replace those batteries, with t
Electronics Forum | Mon Feb 02 13:14:11 EST 2004 | kauer
Hey, going to lunch now. Just for kicks, did you try to re-load Mint files? They may have been lost some other way, I have seen the DEK software do some crazy stuff in the past. Talk to You in a bit.
Electronics Forum | Wed Dec 07 22:39:03 EST 2005 | Alan
Robert, you will have to re-load the MINT software. It only takes a couple of minutes to do this. This will fix out the errors. Refer to your DEK manuals on how to carry out this function. Cheers, Alan.
Electronics Forum | Fri Dec 09 02:26:31 EST 2005 | Alan.
Robert, power on the machine and go straight into DOS. You can do this by pressing and holding the Shift key as the machine is booting up. Run MINT. Try re-seating the cards too before you do this. Have you checked the voltages on the card batteries.
Electronics Forum | Mon Feb 02 14:06:27 EST 2004 | jsk
I did reload mint. When i do this the machine runs fine for about 15 minutes, but i have to continue loading boards. If I let the machine idle for 3-5 minutes, i get the error. We are a low volume manufacturing company, so on a 20 piece run i will re
Electronics Forum | Wed Jan 06 15:25:35 EST 2010 | wolverine
Any help would be appreciated We have a DEK 265 Screener that has been showing symtoms of a bad power supply. Is there a way to back up the hard drive and is an executive program needed in case the machine totally dies. Dave
Electronics Forum | Wed Feb 03 15:57:18 EST 2010 | baildl632
We have a DEK 265 also. It may be the PNOZ (relays in a box) or the "in rush" capacitors "leaking" or "opening" causing your power supply symptoms. Went through something that sounds similar to your description of "power supply" problems. Your best o
Electronics Forum | Tue Mar 20 05:03:47 EDT 2012 | sunyb123
Dear sir, i have face same problem of motor Communication fail Card0,Card1,I Clean Whole card properly, change the battery new one ,reprogrammed mint, but Card 2&Card3 loaded the mint programmed but not in card 0 & card 1, Please suggest what to d
Electronics Forum | Thu Mar 22 10:11:47 EDT 2012 | menatech
if you download the mint program (maintance key switched and download via auto mode. Does is read the card correct and does it identifies the correct motor encoder?
Electronics Forum | Fri Aug 24 00:01:23 EDT 2018 | leeg
Have you tried to re-load the MINT software 1st? Are the breakers in at the back of the machine?
.png)
