Full Site - : mint program dek 265 (Page 5 of 15)

Re: DEK 265 opinions needed please

Electronics Forum | Fri May 26 13:16:53 EDT 2000 | Todd

I have worked with MPM and GSP (fuji) and the DEK. I have had the least problems with the DEK. Kept having software issues with the MPM although I have heard some having good experiences. We used the GSP for the through hole but needed new vaccum

DEK 265 to DEK Horizon 2 question

Electronics Forum | Tue Jan 21 08:49:42 EST 2020 | emeto

I am sure you can upgrade it with DEK and it should not be so expensive. You can also ask them the price of the auto system. This is an arm(controlled by cylinder I think) and software to control it. This one moves the stencil in place when you load

DEK 265 Horizon Servo Following Error

Electronics Forum | Wed Dec 13 08:54:28 EST 2017 | raymccomb

We have a DEK 265 and we have fitted new belts to it after one split in use. when we set back up and run program A all is OK, when we go to run program B it has System Error. Servo Following Error - Fatal Error - Reinitialise machine. Does any one h

DEK 265 to DEK Horizon 2 question

Electronics Forum | Fri Jan 17 09:34:22 EST 2020 | emeto

It looks like you have a simple version of the Horizon. You should have a scale on the right side with a stopper. When you create a new program you will define where the stopper should be. I used to same this value in the program description field, s

DEK 265 and FUJI Board Loader

Electronics Forum | Mon Dec 06 00:44:45 EST 2004 | donb

You probably have already done this... but you need to enter the maintenance program with the maintenance key, select "Set Prefs" scroll down to "Upline Machine" and enter "Fuji".

DEK HORIZON 265 Squeege Pressure question

Electronics Forum | Sat Nov 09 21:57:00 EST 2019 | dekhead

Not to be disagreeable, but sounds like "RichC" is describing earlier series 265 calibrations... (based upon location of PSR Amp and magnets to bypass cover interlock a 265MK1 (v. 1992-94). That "readings" calibration on your mach

DEK 265 motor com error, axis 1,2,3 fatal error

Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas

hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s

DEK265 GSX

Electronics Forum | Fri Apr 19 01:42:35 EDT 2013 | dman97

Sounds like you need to run the MINT program. Boot the machine into MSDOS mode change directory to mint and type load. Let the machine auto detect the cards and re download the software to all cards.

Dek265 mk1 power problem

Electronics Forum | Mon Jan 06 14:02:00 EST 2020 | dman97

Have you tried to open the MINT program and re download the drivers to the cards? Sometimes the cards fail because the battery does not hold sufficient charge to keep the files intact.

DEK265 Calibration problem

Electronics Forum | Sat Feb 25 11:23:58 EST 2006 | Curt

You may need to re-load the MINT files.


mint program dek 265 searches for Companies, Equipment, Machines, Suppliers & Information