Electronics Forum | Wed Nov 02 11:42:54 EDT 2022 | bobpan
check 'machine' then 'parameters' and make sure 'part check wait delay' is set to 0. Also I would turn off CDON usage in 'ANC' for each head. If they are set to 'YES' change them to 'NO' and see what happens.
Electronics Forum | Thu Jun 29 16:15:40 EDT 2023 | bobpan
The amplifier has probably gone bad. I have had to replace a few over the years. Swap it with another machine if you have one. good luck
Electronics Forum | Thu Mar 29 09:07:48 EDT 2018 | gfe
I work with lines MX200l and MX 200LP, one of them is with camera analogue the others with digital cameras, the oldest one (analogue camera) is faster than the others, but there is a line that must have a delay in the pick and place, someone knows wh
Electronics Forum | Fri Aug 26 10:44:37 EDT 2022 | gfe
In the Mirae machine we can give an individual delay for each component, in this case the delay in Z is in all of them, the nozzle stays on top of the component for a long time, this happens in any program, could we have accidentally changed some con
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Fri Mar 30 06:59:00 EDT 2018 | bobpan
In Production Monitor....there is Utility and Axis speed. Make sure the z-axis are set to 100%. I would also check to make sure in your component information that you dont have your parts slowed down or have long place and/or pick delays. good luck
Electronics Forum | Thu Apr 30 05:22:40 EDT 2020 | bobpan
There is a sensor that monitors the temperature of the x and y1/y2 axis on the machine. You have a possible problem with the x temp sensor. There is also a temperature board that is located in the leg area below the keyboard. I am attaching a picture
Electronics Forum | Tue Nov 01 18:41:10 EDT 2022 | griinder
misc. Info), and the profile in component editor under the other tab. Default is 20. There is a way to change numerous values at once, but it takes a hidden click and password to do. First verify both places for a part are set to 20. Is it possible
Electronics Forum | Tue Oct 15 03:57:02 EDT 2019 | kartaviiork
Hello, i am have experience in calibration by hand by input to offsets (some times jigs are not perfect). Also I could try to answer to some questions about Mx Mr Mirae series.
Electronics Forum | Mon Jan 13 08:35:51 EST 2020 | griinder
The holes are calibrated in MSetup. Generally, I have never had luck using the auto teach for the nozzle changer. We would teach them each manually. Before doing this, you need to narrow your issue down a bit more. Which head gives you this error?
.png)
.gif)
