Electronics Forum | Tue Sep 16 19:13:28 EDT 2008 | hegemon
Our Mirtec MV3 Benchtop machine came with its own table. Others may or may not. During our evaluation of AOI machines we had 2 other units set up on standard workbenches at times. A solid, shake free table is a MUST, the heavier the better. There i
Electronics Forum | Sun Oct 17 11:26:36 EDT 2010 | methos1979
New to this forum and AOI. After an exhaustive search and review my company purchased our department a Mirtec MV-3L desktop AOI system. We use a combination of SMT and through-hole components in our product. I am currently learning to program th
Electronics Forum | Fri Feb 04 16:55:29 EST 2011 | rodrigo
Thanks for the reply. I understand the second owner package is $6k plus travel fees. Is there another option for getting the newer software ... at a much lower price? Is the newer software that much better than the one we're using? A do-it-yourself k
Electronics Forum | Thu Feb 17 14:39:07 EST 2011 | rodrigo
Hi all, The ATT sometimes does this when I'm teaching parts. It replaces the reference designator with an alternate name. The part gets the inspection window and it is inspected. I want to change these alternate names to the correct reference design
Electronics Forum | Wed Feb 23 13:21:12 EST 2011 | rodrigo
Hi all, This machine is working good now. I wanted to mark some of the bad stuff with the marker but I can't get the marker to do anything. The options is "installed" and the pen moves if I go to Marker Test. I thought it would put a mark when I hit
Electronics Forum | Thu Jan 31 08:27:32 EST 2013 | phase1
Hello, We have just aquired an MV-2HTL AOI with the NG marker option. We are looking for someone familiar with these machines to provide training. I have programmed a board already using the manuals but am not confident as to what values and passing
Electronics Forum | Fri Feb 13 08:41:45 EST 2015 | emeto
Hi, I have MV-7xi from Mirtec. Mine is equipped with the best camera they have as well as telecentric lens which give you very good resolution and view. Machine handles very good most of the defects in SMT. However, when we go to the solder joints i
Electronics Forum | Wed Aug 12 17:57:32 EDT 2020 | glasscake
Due Diligence Post: Figured out my issue with the laser itself, it was set up in RS422 mode and it should have been setup in 0-10v analog out. As far as actually using the tools i have not got that far yet but I will DD again when I get that far. I
Electronics Forum | Mon Mar 28 23:44:51 EDT 2022 | glasscake
Looking into getting an upgrade for the Mirtec MV7-U I have currently. I like the machine and the software is good but the 18k machine registration fee and refusal to supply manuals, replacement parts, ext is rather annoying. What recommendations a
Electronics Forum | Wed Nov 03 14:08:55 EDT 2010 | clampron
Good Afternoon, I would throw my vote in to Mirtec as well. I also had an opportunity quite a few years ago to compare three systems side by side. At the end of the evaluation, the Mirtec stood out over the rest. Over the past several years, I was in