Electronics Forum | Sat Jan 22 18:16:05 EST 2011 | eadthem
Hey "vpblf" i was wondering if you had herd much from mirtec about fixes for the repair plus issues?(good image duplicated on bad image, no arrows, missing good or bad images, missing problems, problems from a different board showing up under the wro
Electronics Forum | Thu Jan 18 09:11:35 EST 2007 | AR
Hello Chris, Are you inspecting wave soldered boards as well with the Mirtec? I hear that inspecting wave soldered boards is so much more complicated than reflowed boards, no doubt due to the varying shapes of even perfectly acceptable solder joints
Electronics Forum | Tue May 18 14:48:15 EDT 2004 | Vinnie
I am not sure but I thought the black fiducial is used for X-out board/panel.
Electronics Forum | Tue Apr 23 15:19:35 EDT 2024 | tey422
The impact of course is a lot less for newer PnP, but for older machine there might be different story. What if the bad marks not being read correctly? The result would be "good" board being skipped, while "X-out" being loaded. That would waste mu
Electronics Forum | Thu Apr 11 11:24:55 EDT 2013 | markhoch
Thank you for your advice Eric. Different SMT Machine Platforms have different methods for handling these PCB Panels with bad circuits. (Commonly known as "X-outs"). Some platforms allow you to identify X-Outs simply by darkening in the first fid
Electronics Forum | Wed Apr 23 10:19:53 EDT 2008 | mikesewell
Has anyone tried to increase the working height on their Mirtec AOI. We have several MV-2HTL machines and have a few boards that are over 2" tall. I'd rather not leave the parts out and have a secondary step to install them after inspection. I've
Electronics Forum | Fri Jan 14 15:36:15 EST 2011 | bdamico
Hello eadthem, MIRTEC sells a center board support for our desktop series. Please contact our office directly for more information regarding this option. I beleive that we might be able to offer you additional assistance with your side angle progr
Electronics Forum | Thu Jul 16 08:47:49 EDT 2020 | mcbasol
Hello everyone, I'm in a manufacturing environment with a middle mix of boards, and some mid volume. The cards are our design and the most diffucult pakage is TSSOP-14, QFP-128 and 0603. So, we have deciced to buy Mirtec MS-11 3D. What is your experi
Electronics Forum | Fri Nov 04 09:29:36 EDT 2011 | remullis
You should also have a backup calibration file to reinstall. If its software related this would put everything back to spec. Mechanically I would call Mirtec as well to ask the best method so that you dont have to reteach all your boards.
Electronics Forum | Wed Nov 07 02:05:54 EST 2018 | robl
If you are just checking rework or for damage and not building boards you probably want a comparator instead - so in Mirtec terms an old MV2 or something new and low cost and much simpler like: https://www.quins.de/QuinsWeb/Systems/system_easy.jsp
winsouce.jpg)
