Electronics Forum | Sun Oct 24 08:07:06 EDT 2021 | artem
Hello, I have a Mydata TP11-UFP which stopped working. It prints F-MOT1-38/245:MSETDYNX during initialisation. Any idea what could be wrong? I have already replaced the capacitors and the Inrush Current Limiters on the "L-19-588-18" board. Also ins
Electronics Forum | Thu Mar 10 23:23:56 EST 2005 | pmd
We have a MyData TP-9-2 with a in line Y wagon. It is a long screw and the vintage is 1994. The Y wagon vibrates at about 24 micrometers at about 25 hertz. Burnin reviels zero encoder pulse errors. Hystersis test indicates a Y axis Y wise varance of
Electronics Forum | Fri Nov 30 11:04:23 EST 2007 | slthomas
Sounds like Mydata might be one you could look at, for example. I don't have experience with them but they do have "smart" feeder capability. Some machines use electronically controlled and motor driven feeders, some use pneumatic and/or mechanicall
Electronics Forum | Wed Apr 15 12:57:37 EDT 2009 | bk
I'm not sure if you fixed your problem yet or not but i'll give you some insight on your problem. The x wagon motor doesn't move cause of the voltage it actually moves when there's current applied to it. The voltage dictates the direction the motor m
Electronics Forum | Tue Nov 13 12:02:54 EST 2012 | jaimebc
I'll try swaping cards and see if the problem follows the card. So far, my guess would be the motor going bad. I did change the brushes, X wagon cables and every cable that goes to the midas unit. But that didn't fix it. The problem is that to replac
Electronics Forum | Fri Nov 22 10:24:28 EST 2019 | rgduval
When you swapped the MOT card, did the proble move to another axis? I'm guessing no, but, wanted to clarify. If the problem did not move, you either have an x-motor problem, x-motor counter problem, or x-transducer problem as noted. Or, a cable pr
Electronics Forum | Wed Mar 04 12:51:41 EST 2020 | bk
That error means your hydra z did not reach it's specified position. With the machine on you should be able to manually push the hydra down and let it come back up. Make sure it isn't being held up or hitting anything as goes down. Lots of times a pa
Electronics Forum | Fri Dec 28 13:11:13 EST 2001 | cyber_wolf
Chris, I have worked with all kinds of Mydata's TP9,TP11,MY series machine for years. I have ran them, programmed them,and had just about every nut, bolt,motor, and circuit board out of them at one time or another.I have also written specialized mai
Electronics Forum | Wed Jul 18 06:47:38 EDT 2007 | cyber_wolf
I was asking if it was a TP9 2U...... If you have a UFP machine then you are in luck. It is most likely the small X-motor. You can test it in the service program. Does the X-axis bounce when you are trimming magazines and stepping through placement
Electronics Forum | Tue Jan 04 13:00:07 EST 2011 | bk
The only x fan i can think of would be the x belt motor fan which is on the back of the black box sticking out of the back of the machine. If it's a heat issue then first thing to do is replace the 2 filters behind the 2 vented covers located on the
.png)
