Electronics Forum | Wed Jan 06 22:10:04 EST 2021 | emeto
Measure if you have power where the light should go. Don't remember but it is probably 5V bulb/12V buld(it should say on it). if you have power, measure the bulb. I am not sure how new you new bulbs are.
Electronics Forum | Fri Mar 05 12:24:34 EST 2021 | astarotf
Hello Our problem was the camera that was bad, we replaced it and it worked again, greetings!
Electronics Forum | Mon Mar 15 18:03:21 EDT 2010 | smt_guy
hi, check the home sensors if they are working specially on the right side rail of the camera where you had the failure.
Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Tue Mar 02 04:30:32 EST 2010 | sigmaprint
Hi. It sounds like you may have the problem under control as you have ordered parts but if it still doesn't work please don't hesitate to contact us at sales@accuspares.com or visit our website http://www.accuspares.com. We should be able to help....
Electronics Forum | Thu Feb 25 14:42:41 EST 2010 | vms
Hello would you want to sell it? Harry
Electronics Forum | Thu Feb 25 06:59:04 EST 2010 | ristikas
Probably the ribbon cable are broken. I had same issue some time ago. Cable connected to camera and placed under cover. Spare part code is 1007867.
Electronics Forum | Tue Mar 02 03:41:13 EST 2010 | ristikas
Unfortunately i am not a seller. I am ordering the part from sincotron.eu I dont know your location but if you are in EU then contact them.
Electronics Forum | Sat Feb 10 10:08:04 EST 2018 | griinder
We recently acquired used MPM Accuflex. Immediately I noticed the live vision is mirrored. This makes it incredibly difficult to teach fiducials. I noticed some smudges on the lens, which leads me to believe the camera assembly was "worked on" at som
Electronics Forum | Tue Sep 24 15:32:22 EDT 2019 | kurtiss
During production our MPM Accuflex stopped working. When going into "Play" mode to run production it almost instantly Pauses. When going into vision setup it fails to load the PCB saying "The PCB Did Not Load". Ignoring this error and trying to read
.png)
