Electronics Forum | Mon Feb 22 15:44:42 EST 2010 | remullis
Just bought a used machine and everything was working fine and now the camera will not initialize. Powered down completely and rebooted, same thing. I powered down again moved camera to center of axis, it moves to the lower right hand corner which I
Electronics Forum | Thu Dec 30 20:48:09 EST 2021 | openindus
We acquired the machine few weeks ago and it was working fine until the printer won't initialize anymore with "USC park failed" error. It seems that the printer won't respond to "4 MAXY_SP 61,0" message. Is someone has already en
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Tue Feb 01 19:02:48 EST 2022 | proceng1
USC PArk is your underside stencil cleaner. The camera pushes it back and a magnet grabs it and holds it back. Ours did this many years ago. I pulled the rear cover and initialized the machine, when the camera pushes the stencil back, grab it and
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer