Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Sun May 09 09:23:27 EDT 2004 | Sam
Harry, Yes, the model is AP-20 and the computer is 386. I think the system disk was damaged by floppy driver that did not do the maintenance before reading the disk. I have do the test with the common disk that insert to the driver after do maintena
Electronics Forum | Thu Jan 19 18:11:45 EST 2023 | atpico
My UP2000 HiE Printer on Power-ON during initial Reset will show this error and reset will abort with no way to continue. E00938 10 - HARDWARE LIMIT WARNING In Input/Output Screen all Sensors are in normal situation and will react normally when t
Electronics Forum | Wed Dec 14 09:46:48 EST 2016 | westshoredesign
So recently I attempted to do the trackball upgrade for our MPM SPM printer, the touchscreen was unable to calibrate correctly. Unfortunately upon reboot after installing the software the PC wont boot into MS-DOS. It's still functional, as I can brow
Electronics Forum | Tue May 27 15:11:13 EDT 2014 | dekhead
1. Rising Table Position error is, most commonly an issue of motor movement or sensor(s); Not receiving an expected input (sensor input / 'DONE' signal) in expected period of time. Try homing table in Diagnostics see if it moves and what movements ar
Electronics Forum | Thu Nov 21 20:23:26 EST 2013 | dandin87
We have a Speedline MPM UltraPrint 500. The Hard drive currently in it has bad sectors, and so I had tried to install a new hard drive and used the installation folder from the old one to re-install SigmaPro 32. When I start it fails to find the Mete
Electronics Forum | Wed Sep 20 19:34:13 EDT 2000 | Dave F
Congrats. You now control the source of almost 70% of the defects of your SMT operation. There is a neat series of presentations on printing, each year at SMI. One of the best of the SMI series was in 1997, because presenters used a common board
Electronics Forum | Sun Aug 28 23:53:58 EDT 2016 | aemery
I don't think there is a camera off message in the software, but I might be wrong. So I am making a bit of an assumption here that you didn't have a displayed image and your error was a fiducial not found error. I am also wondering if you decided to
Electronics Forum | Mon Jan 25 15:51:02 EST 2016 | aemery
SP1 is a bi-metal spring loaded switch or the "air fault" switch on the main air manifold that detects the presence of an appreciate amount of air being supplied to the machine. Air pressure overcomes the adjustable spring and closes the contacts.
Electronics Forum | Mon Oct 08 15:41:33 EDT 2007 | bbarton
Worked for MPM for many years, and this sounds like a fairly common problem which is easy to fix if you can answer a few questions, several of them already asked... 1. Is this happening only on this board (if the answer is yes, this is a good thing!
.jpg)
