Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
Electronics Forum | Thu Oct 20 13:34:08 EDT 2011 | babe7362000
I checked the housing and it can move up and down freely. I went into Cal and also moved it without a problem. The sensors in the digital I/O seem to be fine. I checked the voltage going to the driver card and it seems to be fine. I think I will s
Electronics Forum | Thu May 13 16:54:55 EDT 2004 | Kuru
I just installed a used Tactile sensor unit, Now it now reads error "Tactile Sensor sensor never closed". If anyone knows or seen this problem pls help. I have adjusted the flag on the photosensor.The photosensor appear to be functioning but the step
Electronics Forum | Tue May 04 16:04:40 EDT 2004 | Kuru
Your are right my trackball was the problem, Now it resets and error on Tactile sensor. If anyone knows where I could get used parts beside MPM, please let know. Thanks
Electronics Forum | Mon Jun 19 21:25:47 EDT 2006 | Chris
Try raising the table in Calibrate mode. Sensor or Tactile connector could be contacting the underside of the rails and overloading the axis. Check for 24V on the Z-axis brake. Check the fuse(F5) and voltage to the driver. Check DIP switch settin
Electronics Forum | Fri May 14 12:40:03 EDT 2004 | Kuru
My switch is good, I can check the switch and the two photo sensors on the input test screen. They are turning on and off.I can see it no the board too. When I start up I can see Tactile unit come down so I know pneumatics portion is good. I am still
Electronics Forum | Fri Feb 15 13:45:18 EST 2013 | cowens
We have a MPM UP2000. We are getting a hardware limit error when we turn the machine on and try to reset. The F14 fuse blows every time we replace it. The downstop is the first axis that it tries to go through but we get this error. Any help would be
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
Electronics Forum | Sat Jan 21 11:39:11 EST 2023 | atpico
Thank you Michal, The MPM error messages are ambiguous to say the least and one axis not zeroing was a possible cause. But I put here what I learned again and again with this machine: when something doesn't work start by checking the fuses, all of
Electronics Forum | Thu Oct 21 11:15:00 EDT 2010 | jorge_quijano
Do you know in which axis the problem occurs? usually when "hardware limit error" shows is because one of the axis touches the sensor of the limit, this is to prevent the mechanism hit something, If you machine is used, you can check if there is a mi